EZ TRAP 3/4ʺ Standard Condensate Trap with Brush 83114 Installation Guide
- June 6, 2024
- EZ TRAP
Table of Contents
U.S. Patent Numbers 5,069,042 5,522,229
Model No. (EZT113)
83114
(EZT 113B)
3/4ʺ Standard Condensate Trap
with Brush 1” DROP
Kit Contents
3/4″ Standard Trap (1)
3/4″ Cross (1)
3/4″ Tee (1)
Red Caps (3)
Yellow Cleaning Label (1)
Cleaning Brush (1)
Scan for more infohttp://www.rectorseal.com/qr/airtec-eztrap.html
3 YEAR WARRANTY. The manufacturer disclaims all implied and express warranties, including the implied warranty of merchantability and the implied warranty of fitness for a particular purpose, except as follows: The EZ-Trap condensate trap or overflow switch purchased by you is unconditionally guaranteed to be free from defects in material and workmanship under normal use for a period of three (3) years from the date of purchase, providing it is installed and operated strictly in accordance with manufacturer’s installation instructions. If the product is found to be defective or otherwise fails in normal use, you may return it for replacement. All freight charges for the return of the product shall be borne by you. The manufacturer will pay outgoing freight charges for the replacement product. Defective products returned to the factory prepaid will be repaired or replaced free of charge. Replacement product will, to the extent such product is then available in manufacturer’s inventory, be of similar type, color and kind. The manufacturer retains the right to substitute the product if the replacement product does not conform in terms of color, type, and specifications to the original product, if no longer available. This warranty does not cover replacement labor or any cost, claim, or incident to any defect nor does it cover freezing or any other consequential damages. The sole liability of the manufacturer under this warranty is limited to the replacement of defective product. Product damaged by improper use, accident, neglect, alteration, abuse, or improper installation is excluded from this warranty.
Important:
Install in strick accordance with RectorSeal instructions as well as all
applicable local plumbing, drainage and electrical codes.
Trap Assembly Instructions
-
Dry fit, and mark components, rotating U-Bend (B) and Cross Tee (C) to required angles for installation.
-
Glue components (A thru C) using dry fit markings.
Then glue assembly into Drain Pan Line -
Glue Drain Line (E) into the center leg of Outlet Tee (C).
Drain Line must exit the building with at least a 5°angle. -
Check that Red Cap (D) is tightly secured.
-
Attach cleaning label as indicated.
Note: Insulation is required when a trap is installed in an unconditioned space where sweating can occur
RectorSeal® 2601 Spenwick Drive – Houston, TX 77055
ph: 713.263.8001 – 800.231.3345 fax: 713.263.7577 – 800.441.0051
www.rectorseal.com – Like Us on Facebook
961680