ifi ZEN-Phono Preamp for Turntable Record Players Instructions
- June 6, 2024
- ifi
Table of Contents
- ifi ZEN-Phono Preamp for Turntable Record Players Instructions
- 1. Power ON/OFF
- 2. MM input LED
- 3. MC HIGH input LED
- 4. MC LOW input LED
- 5. MC V-LOW input LED
- 6. SUBSONIC Filter ON/OFF
- 7. Balanced 4.4mm analogue output
- 8. RCA analogue output
- 9. Ground
- 10. RCA analogue input
- 11. Gain channel switch
- 12. DC 5V power
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
ifi ZEN-Phono Preamp for Turntable Record Players Instructions
Thank you for purchasing the Phono from the ZEN series. The Phono is a balanced MM/MC phono stage.
1. Power ON/OFF
This is the power switch.
Note: If the unit is turned on for a while, you need to shut off the unit
twice to turn it off. It only happens if the unit is on for a while. This is
because the MCU will have switched out of the signal path so you get to enjoy
the best sonics!
2. MM input LED
This is a MM input suitable for MM cartridges with the output voltage higher than 2mV. Please select Gain 1 at the rear.
3. MC HIGH input LED
This is a MC HIGH input suitable for MC cartridges with the output voltage less than or equal to 2mV. Please select Gain 2 at the rear.
4. MC LOW input LED
This is a MC LOW input suitable for MC cartridges with the output voltage less than or equal to 0.5mV. Please select Gain 3 at the rear.
5. MC V-LOW input LED
This is a MC V-LOW input suitable for MC cartridges with the output voltage less than or equal to 0.25mV. Please select Gain 4 at the rear.
6. SUBSONIC Filter ON/OFF
This is the SUBSONIC filter switch.
The iFi-designed subsonic filter will intelligently detect whether a subsonic
frequency is a warp or a bass note. It will eliminate the warps and let all
the bass and mid-range frequencies pass through untouched. Therefore, it will
not affect the sound quality.
7. Balanced 4.4mm analogue output
This is an analogue output via 4.4mm > XLR or other balanced interconnects. You could use this for an active speaker or an amplifier.
Tip: As ZEN Phono is balanced, this is the recommended output.
8. RCA analogue output
This is an analogue output.
9. Ground
This is the ZEN Phono’s ground, please connect it to the turntable’s grounding wire.
10. RCA analogue input
This is an analogue input.
11. Gain channel switch
This button cycles between 4 gain levels:
- corresponds to MM: (>2mV)
- corresponds to MC HIGH: (≤2mV)
- corresponds to MC LOW: (≤0.5mV)
- corresponds to MC V-LOW: (≤0.25mV)
Please adjust the gain channel switch in accordance with your preference and your turntable’s specifications.
12. DC 5V power
Please connect the ZEN Phono to the enclosed power supply.
The ZEN Phono must ONLY be powered by 5 volts.
For best performance upgrade the enclosed power supply to a super-silent iPower 5V or the ultra-low noise iPower X 5V power supply.
Specification
Specifications are subject to change without notice.
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>