LANKOTA LANEC100 Universal 16 Pin to 31 Electrical Adapter Installation Guide
- June 6, 2024
- LANKOTA
Table of Contents
LANKOTA LANEC100 Universal 16 Pin to 31 Electrical Adapter
Part List
Procedure
When using an adapter harness to utilize older 16 pin heads to 50 series
combines, it may be necessary to cut a wire to make various heads work
properly.
Note: Various error codes are displayed if the proper wires are NOT cut
or NOT connected.
- This adapter Harness will NOT work with a Dial-A-Matic head on 60 series and newer combines.
- The use of an EC100 adapter harness on 50 series combines will work if the following chart is followed. Sensibility and performance will be as good as it was on the 9000 series combines.
Head| Header Control System| 16 Pin
(Blue)
| 28 Pin
(Green)
| 17 Pin
(Yellow)
| 18 Pin
(White)
---|---|---|---|---|---
Pick-up| With Potentiometer Sensor| Cut| OK| OK| Cut
Pick-up| Dial-A-Matic| Cut| OK| OK| OK
Draper| All heads with or without contour master| OK| Cut| OK| Cut
Corn Head| All heads with or without contour master| Cut| OK| Cut|
Cut
Flex Platform| With Potentiometer Sensor with or without Contour Master| OK|
OK| Cut| Cut
Flex Platform| Dial-A-Matic Height Sensor with or without Contour Master| OK|
OK| Cut| OK
Rigid Platform| All heads with or without contour master| OK| Cut|
Cut| Cut
Row Crop| With Potentiometer Sensor| Cut| Cut| OK| Cut
Row Crop| Dial-A-Matic Sensor| Cut| Cut| OK| OK
For further technical assistance, call Lankota Inc. at: 1-866-526-5682
www.lankota.com | Lankota Inc.
John Deere and JD are registered trademarks of Deere & Company. Lankota is a registered trademark of Lankota Group.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>