makita ADP10 18V Battery Charger Adapter for DC40RA Instruction Manual
- June 6, 2024
- Makita
Table of Contents
makita ADP10 18V Battery Charger Adapter for DC40RA
IMPORTANT: Read Before Using.
IMPORTANT SAFETY INSTRUCTIONS
This manual contains important safety and operating instructions for the interchangeable adapter.
- Before using this adapter, read all instructions and cautionary markings on this adapter, battery charger, battery cartridge, and product using the battery.
- CAUTION – To reduce risk of injury, charge only Makita rechargeable batteries. Other types of batteries may burst causing personal injury and damage.
- Use this adapter with the battery charger below.
- DC40RA
- This adapter cannot charge non-rechargeable batteries.
- Use a power source with the voltage specified on the nameplate of the charger.
- Do not charge the battery cartridge in presence of flammable liquids or gases.
- Do not expose this adapter and battery charger to rain, snow, or wet condition.
- Never carry charger by cord or yank it to disconnect from receptacle.
- Do not carry charger by this adapter installed to the charger or by the battery car-tridge installed to this adapter. Otherwise it may cause falling and result personal injury.
- After charging or before attempting any maintenance or cleaning, unplug the charger from the power source. Pull by plug rather than cord whenever discon-necting charger.
- Make sure cord is located so that it will not be stepped on, tripped over, or other-wise subjected to damage or stress.
- Do not operate charger with damaged cord or plug. If the cord or plug is damaged, ask Makita authorized service center to replace it in order to avoid a hazard.
- Do not disassemble this adapter. Reassembly may result in a risk of electric shock or fire.
- Do not operate this adapter if it has received a sharp blow, been dropped, or otherwise damaged in any way; take it to Makita authorized service center. Incorrect use may result in a risk of electric shock or fire.
- Do not charge battery cartridge when room temperature is BELOW 10°C (50°F) or ABOVE 40°C (104°F). At the cold temperature, charging may not start.
- Do not attempt to use a step-up transformer, an engine generator or DC power receptacle.
- Do not allow anything to cover or clog the charger vents.
- Do not plug or unplug the cord and insert or remove the battery and adapter with wet hands.
- Never use gasoline, benzine, thinner, alcohol or the like to clean this adapter. Discoloration, deformation or cracks may result.
- This adapter are not intended for use by young children or infirm persons with-out supervision.
- Young children should be supervised to ensure that they do not play with this adapter.
PARTS DESCRIPTION
Fig.1
- Battery cartridge
- Interchangeable adapter
- Terminal cover
- Charging light
- Battery charger
Charging time
The charging time is as following table.
*A
(V)
| B| C
(Ah)
| D| E
---|---|---|---|---
DC40RA
14.4| BL1415NA| 1.5| 4| 15
BL1430B| 3.0| 8| 22
BL1460A| 6.0| 8| 40
18| BL1815N| 1.5| 5| 15
BL1820B| 2.0| 5| 24
BL1830, BL1830B| 3.0| 10| 22
BL1840B| 4.0| 10| 29
BL1850B| 5.0| 10| 35
BL1860B| 6.0| 10| 40
A. Voltage
B. Battery type
C. Capacity
D. Number of cells
E. Charging time (min.)
NOTE: Charging time varies by temperature (10°C (50°F)–40°C (104°F)) that battery cartridge is charged at and conditions of the battery cartridge, such as a battery cartridge which is new or has not been used for a long period of time.
Charging
CAUTION : Follow the steps instructed in this manual. If you insert the battery with the adapter to the charger mounted on the wall, the battery or the adapter may come off and fall off.
1. Plug the battery charger into the proper AC volt-age source.
2. Insert the adapter into charger until it stops adjust-ing to the guide of
charger.
3. Insert the battery cartridge to the adapter.
4. When the battery cartridge is inserted fully, charging will begin.
5. After charging, remove the battery cartridge from the adapter while
sliding the button on the battery cartridge.
6. Remove the adapter from the charger while slid-ing the button on the
adapter. Then unplug the charger.
NOTICE: This adapter is for charging Makita battery cartridge. Never use it for other purposes or for other manufacturer’s batteries.
NOTE:
-
The terminal cover of the charger opens as you insert the adapter and closes as you pull out the adapter.
The terminal cover of the adapter also opens as you insert the battery cartridge and closes as you pull out the battery cartridge. -
The pattern of the indicator lamps is varies depending on the charger.
Refer the instruction manual of the charger to check the status of charging.
Makita Corporation
3-11-8, Sumiyoshi-cho,
Anjo, Aichi 446-8502 Japan
www.makita.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>