Plumbline COMO BASIN MIXER Instruction Manual
- June 6, 2024
- Plumbline
Table of Contents
Plumbline COMO BASIN MIXER Instruction Manual
IMPORTANT!
Please read these instructions prior to installation
RECOMMENDATIONS FOR INSTALLATION
ATTENTION: Failure to follow these recommendations may void the warranty. It is recommended that a qualified, licensed tradesperson install this product.
Water Pressure: 3 bar
Product performance cannot be guaranteed if pressure is less than 1 bar. Above
5 bar a pressure regulator must be installed. Failure to do so voids the
product warranty.
Stop Taps/Filters
Angle valves and/or filters are recommended to prevent impurities and debris
entering the mixer.
Water Temperature: 45°-65°C
Pre-Flush
Always flush out the pipework before connecting any tapware. Failure to do so
voids the product warranty.
Flexible Hoses
Before installation check that both end fittings of the flexible hoses are
well tightened/crimped. If in doubt do not install the felxible hose.
Before any bends ensure there is a straight section of the flexible hose from
the hose crimp of at least 1.5-2 times the external (ED) diameter of the hose.
Hand tighten flexi-hoses only. Do not use a spanner with excessive force.
Flexible hose bending radius (BR) should be less than four times the external
diameter (ED) of the hose. Do not install with any tension, twists, pinch
points or sharp bends/kinks.
CLEANING & MAINTENANCE
Cleaning
Clean with warm soapy water and a smooth cloth. Avoid abrasive sponges or
detergents as these will damage the finish.
Cartridge Replacement
Before you start, turn off the water supply to the mixer.
- Remove the handle
- Unscrew the dome (hand tightened)
- Unscrew the locking nut
- Remove the cartridge
Re-assemble in reverse order
Max tightening torque on locking nut: 10-12 Nm
Aerator Maintenance
Remove the aerator, either with a spanner or an aerator cartridge key.
Immerse for half a day in water-vinegar solution (80-20%).
Wash, then reassemble.
Warranty Information
For full details about our warranty visit
plumbline.co.nz/warranty-information
INSTALLATION INSTRUCTIONS
-
Insert the flexible hoses (remembering to hand-tighten only) and the threaded fixing rods.
-
Insert the mixer unit/hoses into the taphole.
-
Slide on the rubber gasket and the metal fixing plate, and wind on the fixing nuts. While holding the mixer in place tighten the nuts using a wrench.
Do not over-tighten – this will crack the basin.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>