OverEZ 1327565 15 ft. Rugged Ranch Chicken Run Adapter Instructions
- June 6, 2024
- OverEZ
Table of Contents
OverEZ 1327565 15 ft. Rugged Ranch Chicken Run Adapter
This Adapter is for all sizes of OverEZ Chicken Coops and Standard & Mini
Chicken Coops with a Rugged Ranch Chicken Run.
You will need a drill or socket set to assemble this chicken run
Assemble
STEP 1:
After the chicken run has been assembled, install the angle iron on the top, bottom and both sides of the insert. The wide one is for the bottom. Install the angle pieces with the angle towards the chicken coop and the lip out (Bottom one is installed the same except the Large OverEZ Chicken Coop and the Standard Chicken Coop, this needs to be flipped with the angle up) Then fasten with 2 self-tapping screws into each panel
STEP 2:
Push the panel against the
chicken coop trim leave approximately 1” away from the latch side of the
chicken coop door. (Optional, insert screws through predrilled holes on the
angle pieces into the trim. You will need to use an extension bit to do this)
STEP 3:
(Optional)
This is only if you have the OverEZ Wire Chicken Coop Panels installed around
the bottom of the chicken coop. Remove the very bottom panel from the insert
by removing the bolts, this is to allow the chickens to walk underneath the
chicken coop. Tie the excess wire from the OverEZ Wire Chicken Coop Panels to
the run.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>