American Technology Components WC7562C Wireless Charger Instructions

June 6, 2024
American Technology Components

American Technology Components WC7562C Wireless Charger Instructions
American Technology Components WC7562C Wireless
Charger

INSTRUCTIONS

  1. Create a cutout in a surface for the charger to drop into, the cutout should measure 4.5″ x 2.75″.
    Instructions

  2. Place wires first into cutout, connect the black wire to ground. Connect the red wire to a 12 volt 2 amp power source, Clean surface and charger where they will meet. Use adhesive to seal charger to top of cutout surface.
    Instructions

  3. Place your phone down (back towards the charger), your phone should indicate that charging has started.

REGULATORY INFORMATION

FCC Statement

This device complies with part 15 of the FCC Rules, Operation is subject to the following two conditions:

  1. This device may not cause harmful interference.
  2. This device must accept any interference received, including interference that may cause undesired operation.

WARNING:

Any  changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment,

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference wilt not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception. which can be determined by turning the equipment off and on. the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
    • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV techniciar, for help.

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.

This transmitter must not be co-located or operating in conunction with any other antenna or transmitter. FCC ID: 2AYP4-WC7562C

RSS Statement (Canada)

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation. Science and Economic Development Cana:la.s licence-exempt RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference. (2) This device must accept any interference. including interference that may cause undesired operation of the device.

This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 10cm between the radiator and your body.

IC: 26863-WC7562C

Declaration de conformite avec le CNR (Canada)

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals