Latch Systems HB2 Hub Installation Guide
- June 6, 2024
- Latch Systems
Table of Contents
Latch Systems HB2 Hub Installation Guide
Things you should know
- For in-unit install, place the hub near the media panel.
- Configuration requires the iOS Manager App running on an iPhone 5S or newer.
- More resources, including the electronic version of this guide, can be found online at support.latch.com
Included in the Box
Mounting Hardware
- Pan-head screws
- Anchors
- Cable ties
Product
- Latch Hub
- Mounting Plate Wire Grommet Cover
Not Included in the Box
Mounting Tools
-
2 Phillips head screwdriver
- T25 Torx screwdriver
- 1/4″ drill bit
Requirements for Device
- 64 bit iOS device
- Latest version of the Latch Manager App
Sold Separately
- Power adapter
- Power adapter extension
- RJ45 Cat5 patch cable
Product Details
Details and recommendations for power, wiring, and product specifications.
LED (Light) Definitions
Solid White – Online and connected
Flashing White – Booting up, connecting, or pairing
Fast Flashing White – Firmware updating
Solid Red – Cannot connect to Latch servers
No Light – Power off or battery out
1/0 Port Definitions
Wiring
DC Power Adapter
Requirements
Input voltage: 90-264 VAC
Input frequency: 47-63 Hz
Output voltage: 12 VDC +/- 5%
Max load: 2 AMPS
Min load: 0 AMPS
Load regulation: +/- 5%
Note: Do not splice DC power adapter
Optional Cable Extension
Sold Separately.
Note: If the DC power adapter (5ft) is not long enough for installation, an additional 5ft extension cable can be used.
Only one extension per hub is supported.
Low Voltage 2 Wire Power
Installation
Follow these steps to proceed with installation.
1.
Rotate Torx screws in outer Cover counter-clockwise to unlock. Separate the outer Cover from the Mounting Plate using the opening on the underside.
Note: Do not use a power tool or excessive force on the Torx screws-over torquing could cause damage.
Rotate Torx screws in Hub counter-clockwise to unlock. Remove the Hub from the Mounting Plate.
2.
Install Mounting Plate. Attach to junction box or attach to wall or ceiling.
Note: Pass cables through opening before attaching Mounting Plate to junction box.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>