Shenzhen Poweroak Newener PS200A Portable Power Station User Manual
- June 6, 2024
- Shenzhen Poweroak Newener
Table of Contents
Shenzhen Poweroak Newener PS200A Portable Power Station
2150Wh Portable Power Station
**Safety instructions
**
Please observe the following instructions to ensure safe usage:
- Do not alter or disassemble this product.
- Do not move during charging or using it, because the vibration and impact during moving will lead to poor contact of output interface.
- In case of fire, use dry powder fire extinguishers for this product. Do not use water fire extinguisher,which may cause electric shock.
- Close supervision is required when using this product near children.
- Please confirm the rated specification of your load, and do not use it beyond the specification.
- Do not place the product near heat sources, such as electric furnace and heaters.
- Not permitted on aricrafts because the battery capacity exceeds 100Wh.
- Do not touch the product or the plug-in points if your hands are wet.
- Check the product and accessories prior to every use. Do not use if it is damaged or broken.
- Please unplug the AC adapter from the wall outlet immediately in case of lightning stroke, which may cause heating, fire and other accidents.
- Use original charger and cables.
General Specs
QUICK GUIDE
- DC 12V/30A Aviation Sockets port
- Power button
- Touchable interaction LCD display
- US AC output x 6 pcs
- PV/Car input port
- Adapter input port
- Wireless charging x 2pcs
- USB-A 5V/3A output x 2pcs
- DC 12V/10A cigarette lighter port
- USB-A 18W output x 2pcs (EU/UK AC output x 4pcs)
- DC 5521 output x 2pcs
- USB-C 100W output
Solar Charging
Safety instructions
What`s In The Box
Optional
FREQUENTLY ASKED QUESTIONS
The adapter (power brick) got hot when I charge it, is that alright?
It’s totally normal for the adapter gets warm, because of the heat produced
in circuit during charging.
Why does the unit shut down automatically with my appliance connecting?
The“ECO MODE”(press then hold for 4s to launch) is set to shut down the
unit when the AC output of the unit is lower than 50W in 4 hours for power
saving.
What cause the cooling fan not to launch?
With the excellent heat dissipation design, cooling fan will only launch
when the total loads exceeds 30% of the rated output.
Can I charge and discharge the power station simultaneously?Y
Yes, it is supported but not recommended in order to protect the lifespan
of battery .
How to claim the warranty?
Please refer to the warranty card or the official website for further
warranty policy.
FCC warning:
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help. FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20 cm between the radiator and your body
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>