AIAIAI S10 Speaker Unit User Guide

: June 6, 2024
: AIAIAI

Table of Contents

Quick Start Guide
Warranty
Regulatory info
Support
Documents / Resources

AIAIAI S10 Speaker Unit User Guide

Quick Start Guide

Product Overview

Power on/off
Press and hold the joystick button for 3 seconds
Pairing
With the headphones turned off, press and hold the joystick button for 6 seconds
Controls
Play/pause: Single press on the joystick button
Volume: Move the joystick up or down Next/previous: Move the joystick right or left
Product Manual
More details
Scan the QR code on the next page for more details

Warranty

AIAIAI TMA-2 S10 speaker units are covered by a 2 year limited warranty. For more information, please visit: aiaiai.audio/help/warranty

Regulatory info

FCC Caution:
Any Changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

This device may not cause harmful interference, and
this device must accept any interference received, including interference that may cause undesired operation.

IMPORTANT NOTE

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

FCC Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.

IC Warning:

This device complies with Innovation, Science, and Economic Development Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:

this device may not cause interference, and
this device must accept any interference, including interference that may cause undesired operation of the device.

The device is compliance with RF exposure guidelines, users can obtain Canadian information on RF exposure and compliance.

To prevent possible hearing damage, do not listen at high volume levels for long periods.

Hereby, AIAIAI ApS declares that the radio equipment type 510 is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: aiaiai.audio

Hereby, AIAIAI ApS declares that the radio equipment type S10 is in compliance with UK Radio Equipment Regulations (SI 2017/1206). The full text of the UK declaration of conformity is available at the following internet address: aiaiai.audio

Manufacturer information:
Company name: AIAIAI ApS
Address: Studiestrwde 31,Copenhagen K, 1455, Denmark

Operation temperature: -20-55°C
Chargingtemperature: 0-45°C
Operation frequency(Max power)
Bluetooth: 2402-2480 MHz(5.5dBm)

Icons
FCC ID: 2AKSOS1001 IC: 23880-TMA2S10

Support

Contact

AIAIAI ApS
Studiestraede 31
1455 Copenhagen K.
Denmark
Email: [email protected]

ENERGY VERIFIED
CSA C 381.2
B0010

Documents / Resources

| AIAIAI S10 Speaker Unit [pdf] User Guide
S1001, 2AKSOS1001, S10 Speaker Unit, Speaker Unit
---|---
| AIAIAI S10 Speaker Unit [pdf] User Guide
S10, S10 Speaker Unit, Unit, S10 Unit, Speaker Unit