Trulyway Electronic Development J101 Wireless Earphones User Manual

June 6, 2024
Trulyway Electronic Development

Trulyway Electronic Development J101 Wireless Earphones User Manual

Trulyway Electronic Development J101 Wireless
Earphones

Product specification

  • Bluetooth version: 5.1
  • Battery input: DC 5V
  • Earphone battery: 30mAh
  • Charge case battery: 300mAh
  • Working time: About 4-5 hours
  • Sensitive: 103+3dB
  • Frequency: 20-20000Hz
  • Profile support: HSP/HFP/A2DP/AVRCP

Operation instructions

Binaural Function:

  • Touch once: Play/Pause
  • Answer/End a call
  • Touch twice on L: Previous song
  • Touch twice on R: Next song Touch and hold 2 sec: Reject the call
  • Touch and hold 2 sec then release: Wake up voice Assistant

FIG 1 Operation instructions

Product Schematic

FIG 2 Product Schematic

  1. Charge Case
  2. LED Display
  3. Charging Port
  4. Touch Area
  5. Earphone indicator
  6. Earphone Charging Port

Charge case

When charging: LED display flashes and shows real electricity Full power: LED display shows 100% Charging time: about 40-60 minutes

Earphone

When charging: red LED lights on Full power: red LED goes out Pair with mobile phone: one earphone flashes red and blue alternately, the other does not flash

Connect successfully: LEDs turn off

Charging time: about 40-60 minutes

FIG 3 Earphone 

Pairing for operating

Step 1. Pick up the earphones from the charge case separately or long touch earphones to turn them on, they will be automatically paired; After the pairing is successful, one earphone’s LED will flash red and blue, and the other earphone will not flash. Step2. At this point, open the mobile phone’s Bluetooth to search earphones’ Bluetooth name then connect with it.

Turn on the earphone

Method A. Touch and hold the area for 2 seconds. Method B. Take out earphones from the charge case, they will automatically power on, and enter automatic pairing.

X When the earphones connect to the same device again, open the lid of charge case it will turn on automatically then reconnect with the device, voice prompt “Connected”.

Turn off the earphone

Method A. Touch and hold the area for 5 seconds. Method B. Put earphones into the charge case, they will automatically shut down and enter charging.

X When the earphone disconnected for 3 minutes, it will automatically turn off.

Calling

When connected with mobile phone, touch once any earphone to answer current call. Long touch for 2 seconds to reject the call. If you want to end the current call, touch once any earphone to stop.

Warning:

  1. To ensure the battery life of the earphone, the earphones and the charge case should be charged once in a month.
  2. When charging with charge case please use the 5V/1A charger. Please don’t use the fast charger which over 5V, to avoid damage on the charge case.

FAQ

A. When the earphones can’t be turned on

Check if the earphone has power (after the charge case is connected to the USB, and the earphone is charged in the charge case for more than 1 hour).

B. When the earphones have only one side sound or earphones can’t pair successfully

  1. Make sure that both earphones are powered and can be turned on normally.
  2. When the earphones are in the off state, press the earphones for 7 times to restore the factory settings.
  3. Touch 3 seconds to turn on the earphones or take the earphone out of the charge case(when the charge case is powered ) the earphone will power on voluntarily, then you can connect with the device.

C. When the mobile phone cannot find the device

  1. Confirm that the two earphones are turned on.
  2. Check if the earphone is connected to other devices.
  3. Change a clear area and reconnect it again.

D. When the earphone is stuck or disconnect while talking or playing music

  1. The earphone is low on battery.
  2. The distance between the mobile phone and the earphone is more than 10 meters.
  3. There is large area of signal obstruction between the mobile phone and the earphone, such as a wall.
  4. The left and right ears are not paired and synchronized, and need to be shut down and re-paired.

Attention

  1. Please don’t change the built-in battery by yourself.
  2. Please don’t put the headset under wet or rainy place.
  3. Please don’t expose the headset under the blazing sun, event not close fire to avoid battery accidents.
  4. Please don’t disassemble the headset if unprofessional.

FCC Statement

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions (1)this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Operation Frequency:

For BT/BLE: 2402MHz~2480MHZ

Max Output Power:

For BT: 0.0002W

For BLE:0.0001W

Manufacturer: Trulyway Electronic Development Co., Ltd

Address: 4th Floor, No. 268 of Baoshi East Road, Shiyan Street,

Baoan District, Shenzhen

Tel: +86-0755-85273779 |

Fax: N/A

E-mail: info@trulyway.com

UKCA Statement

This device is in compliance with the essential requirements and other relevant provisions of UK Radio Equipment Regulations (SI 2017/1206); UK Electrical Equipment (Safety) Regulations (SI 2016/1101); and UK Electromagnetic Compatibility Regulations (SI 2016/1091). All essential radio test suites have been carried out.

DECLARATION OF CONFORMITY

I hereby declare that the product

Product: Wireless Earphones
Model No.: J101, TW100, TW200, TW300, J56, J66, J96, M19, M20, G1, G2, G5, G6, G8, G2, G10, H3, H5, H6, H8, H9 H10, X1, X2, X3, X4
Hardware Version: 213P3
Software Version: KMT-J101-V1.4
Trade mark: N/A

Accessories:
USB Cable Information:
Model: N/A
Length: 15cm
Manufacturer: Shenzhen Xinzhiyin Electronic Technology Co., Ltd

Battery 1 Information:
Model: 602030
Specification: 3.7V, 300mAh
Manufacturer: Shenzhen Juzhongxin Electronics Co., Ltd

Battery 2 Information:
Model: 401012
Specification: 3.7V, 30mAh
Manufacturer: Shenzhen Juzhongxin Electronics Co., Ltd
(Name of product, type or model, batch or serial number)

FIG 4 Product Standard

FIG 5 DECLARATION OF CONFORMITY

FIG 6 DECLARATION OF CONFORMITY

Read More About This Manual & Download PDF:

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals