NameLessRC 39E-93A-9E9 Star BEC Module for Gopro8 User Manual

NameLessRC 39E-93A-9E9 Star BEC Module for Gopro8 User Manual

Attention!

• Please make sure all functions on naked GoProp are normal.
• Please DO NOT plugged in the 3-pins power cables when powering on.

It may cause the FC or GoPro mainboard to burn out.

Features

• The NLRC BEC is specially designed for Naked GoPro HERO which weighs about 2.4g, makes your naked GoPro lighter and easier to install on your drone.
• With the pluggable connector, which is easier to connect with your flight controller for power supply and recording.
• Supports 2-6S power in.
• Automatic power-on function.
• Output voltage is 5V@2.1A, avoid the accident of power off which is caused by the insufficient power supply for the FC board.
• Both support LED and BUZZER port. Pad is available for pilots to control the GoPro recording via the radio transmitter.
• Bypassed the Pinio remap and FC doesn’t need to remap.
• Integrated GoPro stock buttons, Power/Mode Button and Record Button
• Integrated GoPro stock LED to know the status of the camera.

Specification

• Item: NameLessRC Star Module
• Weight: 2.4g
• Output: 5V@2.1A
• Input Voltage: 2-6S
• Connector: PH 1.0 3P Connector

Pins Assignment

Set up & Control

1.Start/Stop recording via FC’s LED function(RECOMMEND):

GoPro’s default mode is recording mode. REC should be connect with LED pad.

FC’s set up:

• Switch on LED_STRIP.

• Set up at least 1 LED.
  

• Add range on LEDLOW channel.
  

Control(YouTubehttps://youtu.be/Zfl1dvslcFY):

• Plug in battery and wait for all modules power on.
• Switch on LED channel for at least 5 secs then switch off. GoPro will start recording. LED function is still available during flight.
• Repeat step 2 to stop recording. Please wait at least 15 secs between start/stop recording.

Start/Stop recording via FC’s BUZZER function:

REC should be connect with BUZ- pad.

FC’s set up:

• Add range on BUZZER channel.
  

Control(YouTubehttps://youtu.be/rji8USzdcc0):

• Plug in battery and wait for all modules power on.
• Switch on BUZZER channel for at least 8 secs then switch off. GoPro will start recording. BUZZER function is still available during flight.
• Repeat step 2 to stop recording. Please wait at least 15 secs between start/stop recording.

Install in case

• Cut off the extra parts
  

• Install the lens mount and tighten the screws
  

• Install the lens and BEC board
  

• Install the shell and tighten the screws
  

• Install the carbon board
  

• Install the lens protection back cover
  

• Support Mavic2 Zoom ND filter and general GoPro filter
  
  

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>