eurotech ED-CAMINO90 90CM Wall Canopy Rangehood Instruction Manual

EUROTECH 90CM WALL CANOPY RANGEHOOD
ED-CAMIN090

INSTRUCTION MANUAL

PLEASE READ THIS MANUAL CAREFULLY BEFORE USING YOUR PRODUCT AND KEEP IT FOR FUTURE REFERENCE.
EUROTECH DESIGN’

 Notice

1.1 Thank you for choosing this range hood. Please read the manual carefully before installation or use.
1.2 The installation work must be undertaken by a qualified and competent person who is experienced in installing items used for the removal of contaminated air. Please ensure all liability for any power is connected.
1.3 The manufacturer disclaims all liability for damage or injury caused as a result of not following the instructions for installation contained in the following text.
1.4 The appliance is not intended for use by young children or infirm persons without supervision.
1.5 Young children should be supervised to ensure that they do play with the appliance.
1.6 The Max. number of hobs covered by the range hood should not exceed 4.

Feature

2.1 Our range hoods are manufactured from top-quality materials and offer a superb streamlined effect.
2.2 Equipped with large power, low noise, electric motor, and centrifugal leaf, it offers characteristics of strong suction, low noise, oil nonstick, and is easy to clean.
2.3 The special wind tunnel construction and oil collector design ensure dirt will be abs or bed in a second.

Installation

3.1 The range hoods should be placed at a distance of at least 700mm from the cooking surface for best effect ( If the instructions for installation for the gas hob specify a greater distance, this has to be taken into account). See the pic I. That exhaust air must not be discharged into a flue which is used for exhausting fumes from appliances burning gas or other fuels.
3.2 To install onto the wall every 220mm drill2 holes of 8mm on a suitable place in line on the hood.
3.3 Insert expended screws into the holes.
3.4 Fix Drilling template on the wall. See pic2.
3.5 Add the soot tube (alternative part) to the one-way valve, and put it outdoor. See pic3.
3.6 Insert the U-shaped section (alternative part), make sure it’s firmed (see picA). At this, the hood has been Installed. (see pic4A).

Change lamp

Before changing the lamp, please confirm that the power is switched off. Unplug the connector linking to the lamp, and then press the lamp’s clip to take out the lamp holder, (see PIC4B), change the same lamp (Lamp Max.20W), and then out the lamp holder back, plug the connector.

Notice of Installation

5.1 Before installation, please make sure that there is adequate ventilation of the room when the range hood is used at the same time as appliances burning gas or other fuels and clean up the surrounding area, to avoid suction of the such as bits of broken wood. 5.2 It can not share the same air ventilation tube with other appliances such as gas tubes, warmer tubes, and hot wind tubes. 5.3 The bending of the soot ventilation tube should be 120°C, parallel or above the start point, and should be connected to the outdoor. 5.4 After installation, test carefully on the horizontal degree, see pic5. 5.5 Be sure that the plug is accessible after installation.

Safety Warning

• There shall be adequate ventilation of the room when the range hood is used at the same time as appliances burning gas or other fuels.

  • Do not check the status of the filters while the range hood is operating.
  • Do not touch the light bulb within half an hour after appliance use.
    Avoid opening the gas valve when there is no pan on the stove, as it is damaging for the filters and a fire hazard. Constantly check food frying to avoid the overheated oil may becoming a fire hazard
  • Disconnect the electrical plug prior to any maintenance.
  • The air must not be discharged into a fuel that is used for exhausting fumes from appliances burning gas or other fuels.

• This appliance is not intended for use by young children and infirm persons unless they have been adequately supervised by a responsible person to ensure that they can the appliance safely.

  • Young children should be supervised to ensure that they do not play with the appliance.

• The range hood is for home use only and is not suitable for barbecue, and other commercial premises.

• Ensure a suitably qualified technical person assembles this hood.

• The range hood and its filter mesh should be cleaned regularly in order to keep a good suction effect.

  • Before cleaning, please confirm that the power is switched off.
  • Clean the range hood according to the instruction manual and ensure the range hood is in no danger of burning. There is a fire risk if cleaning is not carried out in accordance with the instructions. The regulations concerning the discharge of exhaust air have to be fulfilled.
  • If any problems occur with the system or the suction ensure that only a suitably qualified person affects any repairs or inspection.
  • Please keep the kitchen well aired at all times. ‘ The exhaust should not mix the waste gas with the gas of other extracting appliances.

• Prior to any maintenance operation ensure that the range hood is disconnected from the power supply. ” Don’t flame under the range hood.

  • If the supply cord is damaged, it must be replaced by the manufacturer or its service agent, or a similarly qualified person in order to avoid a hazard.

Use

3 Speed adjustment see pic6
A. Push the Stop button and the motor will stop.
B. Push the Low button, and the motor runs at low speed.
C. Push the Mid button and the motor runs at mid-speed.
D. Push the High button, and the motor runs at high speed.
E. Push the Light button, and the two lighting lamps light. Push it again the lamp will turn off.

Potential Problems/Solutions

If any problem occurs, please remove the plug from the socket and contact the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard.

blocking
The capacitor damaged| Replace capacitor
The motor jammed bearing damaged| Replace motor
The internal wiring of motor off or a bad smell from the motor| Replace motor
Light does not work, the motor does not work| Besides the above mentioned, check the following
Light damaged| Replace lights
Power cord loses| Connect the wires as per the electric diagram
Oil leakage| One way valve and the air ventilation entrance are not tightly sealed
paint| Takedown the one-way valve and seal with soap or
Leakage from the connection of U shaped section and cover| Take U-shaped section down and seal with soap or glue
Body shaking| The leaf was damaged and caused shaking| Replace the leaf
The motor is not tightly locked| Lock the motor tightly
The body is not tightly hanged| Fix the body tightly
Insufficient suction| The distance between the body and the gas top of too long|  Readjust the distance
The Hood may be installed too close to windows or doors which when open
may cause excessive wind interference| Choose a new place and reinstall the machine
The machine inclines| The loss of the fixing screw| Fix tightly the hanging screw and make it horizontal
The loss of the hanging screw| Fix tightly the hanging screw and make it horizontal

Electrical Diagram

Machine Switch

Electronic Switch

Main Parameters

 Clean

• Before cleaning, Please confirm that the power is switched off
  11.1 Cleaning the surface of the hood every week. Use mild soap or detergent to clean the hood.
  11.2 Avoid the use of scouring powers of dishwasher compounds.
  11.3 Grease filter may be washed using mild soap or detergent when use it three months. (heavy grease build-up may not be cleaned easily and the filter may require replacement)
  11.4 Do not use harsh alkalis or abrasives.
  11.5 Charcoal filters cannot be cleaned and must be replaced when use it six months.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>