Officelink 1074AC1Q Socket Outlet User Manual
- June 6, 2024
- Officelink
Table of Contents
Officelink 1074AC1Q Socket Outlet User Manual
CIXI MINGYE COMMUNICATION AND ELECTRONIC CO.,LTD
INTRODUCTION
The 107 series with 4 sides power outlet, USB charger, wireless charger into an 12cm diameter body. The top cover is available in plastic and glass. It is a perfect choice for every work desk, an universal solution which able to meet different connection possibilities in the workplace.
TECHNICAL PARAMETER
Note:
- When wireless charging does not work, the total output of USB charging is 3.1A*2.
- When wireless charging works, the output of wireless charging is 1A, the output of a set of USB type A and type C connected to the wireless charger is 1.5A.The other set of USB type A and type C charger is 3.1A.
- This product could be used indoor only
- Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Caution:
Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
INSTALLATION AND USE
Place product (OnΦ12cm cut out ) Screw on
Push the button
The socket will rise to the working position by itself
Wireless charger : just put phone on the socket
With USB charger (two type A+two type C)
Push it down to the close position
Control No.：05-1074AC1Q-01 User Manual _2021 Version number：A/0
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>