YOSHIMURA 070BG191400 Fender Eliminator Kit User Manual

YOSHIMURA 070BG191400 Fender Eliminator Kit

THIS PRODUCT IS NOT DOT APPROVED.
Yoshimura R&D of America, Inc. is not liable or responsible for any resulting event caused by the installation of this product. Check with local laws and regulations for compliance prior to installation and use. This product is not intended for use on public highways.

PARTS

Assembly Diagram

Removal

1. Remove passenger and rider seat.
2. Remove the four torx bolts securing passenger seat tray to subframe and lift tray to access license plate light and turn signal connectors.
3. Locate and disconnect license plate light and turn signal connectors.
4. While securely supporting the stock fender assembly, remove the four bolts securing fender assembly to chassis and carefully remove the fender assembly.
5. Remove the rubber wire grommet from the stock fender as it will be re-used with the Yoshimura fender bracket.
6. Disassemble the stock fender assembly and remove left and right turn signals from the stock fender assembly.
7. Cut the stock license plate light connector from the stock fender assembly. Be sure to cut at least a 6” section of wire from the connector.

Installation

1. Install stock wire grommet into 19140-FEBKT, fender bracket.

2. Install 070BG-LH-K1, LED light onto19140-FEBKT, fender bracket using M4X6BHS, 4mm screws.

3. Route wire through hole in 19140-FEBKT, fender bracket and using the BN-SSS-22-18, solder shrink connectors provided in the kit, connect Yoshimura license plate light wires to the stock license plate light wires as follows:
   Red -to- Blue
   Black -to- Black

   • a) Strip the stock fender light wire ends 1/4” – 1/2” and insert into BN-SSS-22-18, solder connectors provided in the kit.
   • b) Center the spliced wire ends in the middle and using a heatgun or lighter, apply heat evenly on the outer edges of the solder connector to shrink and hold wires in place.
   • c) Making sure that the stripped ends are centered, heat the center of the solder connector evenly until the solder begins to liquify.
   • d) Allow to cool completely and tug both ends of the wires to verify that connection is secured. Scan for link to butt connector instruction video.

4. Install 19140-FEBKT, fender bracket to subframe using the stock bolts and supplied 6MMLN, 6mm lock nuts. Torque to factory specifications.

5. Install the stock left and right turn signals onto 19140-TSB-L/R, turn signal brackets.

6. Install 19140-TSB-L/R, turn signal brackets and 070BG-LPF, license plate frame using the M6X16BHS and M6X14BHS, 6mm button head screws, 6MMWASHER, 6mm washers, and 6MMLN, 6mm lock nuts as shown.

7. Route turn signal wires through hole in 19140-FEBKT, fender bracket and through undertail. Secure license plate light wire and turn signal wires to 19140-FEBKT, fender bracket using supplied ZT-400, cable tie.

8. Re-connect license plate light and turn signal connectors.

9. Re-install and secure passenger seat tray using reverse steps of removal.

10. Re-install rider seat and passenger seat.

11. Check for proper function of license plate light and turn signals and that all brackets and components are secure prior to riding.

References

• Yoshimura R&D – Yoshimura R&D of America, Inc

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>