WONDERCISE WDCTC-01 Wireless Tracker Charge User Manual
- June 6, 2024
- WONDERCISE
Table of Contents
WDCTC-01 Wireless Tracker Charge
User Manual
Rated voltage: 5V
Rated current : 400mA
ambient temperature: 0C40C
Environmental humidity: 10%~90%
usage method :
-
Insert the sensor charging base into the 5V USB output port and snap the sensor onto the charging base. At this time, the indicator light of the sensor will flash repeatedly
-
When the sensor is fully charged, three indicator lights will be on, At this time, the sensor can be removed and the wristband can be put in;
-
Connection: the indicator light in the middle of the sensor will flash slowly to turn on the Bluetooth search of the mobile phone;
Waiting for connection
Sensor installation instructions
Put the sensor product into the corresponding middle frame with a bandage and wear it on the leg or arm, as shown in the figure below
Watch strap
Hamstring
Magnetic fastener seat
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
FCC ID:2AQIRWDCTC-01
FCC statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation.
- If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receivers are connected.
- Consult the dealer or an experienced radio/TV technician for help.
RF exposure warning
The equipment complies with FCC RF exposure limits set forth for an
uncontrolled environment.
The equipment must not be co-located or operating in conjunction with any
other antenna or transmitter.
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
IC RF Exposure statement
Radiation Exposure Statement: This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator & your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>