amazon On-Site COVID-19 Test Collection Kit Instructions

: June 6, 2024
: Amazon

Table of Contents

Your kit includes:
What’s included
Register your kit online
Read User Manual Online (PDF format)
Download This Manual (PDF format)

amazon On-Site COVID-19 Test Collection Kit Instructions

Important: Read all instructions thoroughly before you start.

Your test kit includes a biohazard bag, test tube and nasal swab. If you run into problems with your test kit, wipe down the area and discard kit in the waste bin at check-in station. Get a new kit.

Put on gloves. Wipe the station with disinfecting wipes. Then use hand sanitizer.
Remove the lid from the tube. Place the tube in the holder.
Do not spill the fluid in the tube!
Open the swab pouch and remove from the package. Hold at the bottom.
Do not touch the soft tip!
Lower mask below your nose.
Keep your mouth covered.
Swab first nostril.
Insert the soft end of the swab 1 inch. Rub the swab slowly against the inside walls of your nostril at least 4 times.
This should take about 15 seconds.
Repeat in other nostril.
Then place mask to cover your nose.
Place swab into the tube. Break at the indicator line by bending back and forth against the tube.
Tightly recap the tube.
Do not spill the fluid in the tube!
**Place the tube into bag. Remove air and seal the bag.

**

Wipe the station and chair with disinfecting wipes.
Put gloves and trash in the waste bin at your station. Keep your sample.
Put your sample in the collection bin as you exit.

For use under emergency use authorization only. For prescription use only. For in vitro diagnostic use. For use by individuals 18 years of age or older. This product has not been FDA cleared or approved but has been authorized for emergency use by FDA under an EUA for use by authorized laboratories. This product has been authorized only for the detection of nucleic acid from SARS- CoV-2, not for any other viruses or pathogens. The emergency use of this product is only authorized for the duration of the declaration that circumstances exist justifying the authorization of emergency use of in vitro diagnostics for detection and/or diagnosis of COVID-19 under Section 564(b)(1) of the Federal Food, Drug and Cosmetics Act, 21 U.S.C. § 360bbb-3(b)(1), unless the declaration is terminated or authorization is revoked sooner.

Amazon On-Site COVID-19 Test Collection Kit

Your kit includes:

Important reminders

Keep your mask on while in the testing site. Your mask should cover your mouth at all times.
Carefully follow all instructions. If you miss any testing steps your results may be inaccurate or result in an error.
Collect a sample from both nostrils.
The nasal swab tip should not touch anything except inside your nostril.
If the swab tip touches anything other than inside your nostril, discard your kit in the waste bin at check-in, clean the testing area with a disinfecting wipe, and request a new kit.
Do not spill any of the fluid in the tube. If you spill the fluid in the tube, discard your kit in the waste bin at check-in, clean the testing area with a disinfecting wipe, and request a new kit.

Questions?
There is a problem with my kit.
If you cannot complete the test based on the resources available at your testing station, request a new kit.

If you have questions, ask the flow monitor for help.
For additional questions, e-mail: covid19testing@amazon.com

Do not touch or drink the fluid in the tube. If the fluid touches your eyes or skin, rinse with water.

Carefully read all instructions before you start.
If you have questions, ask the flow monitor for help.
Wipe the station and chair with disinfecting wipes. Then use hand sanitizer.
Do not remove gloves during sample collection.
Remove the lid from the tube and place the tube in the holder.
Do not spill the fluid in the tube! If you spill the fluid, clean the area, discard your kit, and get a new kit.
Open the swab pouch from the handle end. Remove swab from the package. Hold by the handle.
Do not touch the soft tip! If the swab tip touches anything other than inside your nostril, clean the area, discard your kit, and get a new kit.
Lower face mask below your nose.
Do not remove mask. Keep your mouth covered while collecting sample.
Swab first nostril.
Insert the soft tip of the swab 1/2 – 3/4 inch. Rub the swab in a slow circular motion against the inside walls of your nostril at least 4 times. This should take about 15 seconds.
Repeat in other nostril.
Then place face mask back to cover your nose.
Place swab into the tube. Break off the swab handle.
To break the swab handle, hold the tube firmly. Bend the handle at the indicator line back and forth against the tube until it breaks. Tightly recap the tube.
Do not spill the fluid in the tube! If you spill the fluid, clean the area, discard your kit, and get a new kit.
Place the tube into the bag, remove air, and seal the bag.
Refer to the important reminders in the left panel to ensure you collected your sample correctly. If you have not collected your sample correctly your test cannot be processed.
Wipe the station and chair with disinfecting wipes.
Put trash in the waste bin at your station. Keep your sample.
Put your sample in the collection bin as you exit.
Remove gloves and sanitize your hands as you exit.

Amazon Onsite COVID-19 Test Collection Kit. For use under emergency use authorization only. For prescription use only. For in vitro diagnostic use. For use by individuals 18 years of age or older. This product has not been FDA cleared or approved but has been authorized for emergency use by FDA under an EUA for use by authorized laboratories. This product has been authorized only for the detection of nucleic acid from SARS-CoV-2, not for any other viruses or pathogens. The emergency use of this product is only authorized for the duration of the declaration that circumstances exist justifying the authorization of emergency use of in vitro diagnostics for detection and/or diagnosis of COVID-19 under Section 564(b)(1) of the Federal Food, Drug and Cosmetics Act, 21 U.S.C. § 360bbb-3(b)(1), unless the declaration is terminated or authorization is revoked sooner.

What’s included

Important reminders

You must register your sample collection kit to get results.
You must wash (or sanitize) your hands before you collect your sample.
Return your sample collection kit to your worksite within 24 hours of collecting your sample. Late samples cannot be processed.
Sample collection takes less than 10 minutes.
For frequently asked questions, visit amazondx.com/testing-faq

Register your kit online

Visitamazondx.com
Or, view the QR code with your camera app.
Sign in or create an account.http://amazondx.com
Confirm your test details
Make sure your name and date of birth are correct. Enter the collection tube ID, found on the side of your collection tube.
Press “Register kit”
Collect your sample immediately after registering. Sample collection takes less than 10 minutes.
You must register your kit to get results.

Watch the overview video during the register kit experience. Re watch the video at: amazondx.com/testing-faq
Collect your sample
Carefully read all instructions before collecting your sample.
Did you register your kit? If not, go back to steps 13. We recommend collecting your sample while seated. Do not touch the soft tip of the swab. Do not touch or drink the fluid in the collection tube. If the fluid touches eyes or skin, rinse with water. If you spill the fluid or the swab touches any surface other than inside your nostrils, clean the area with your routine household surface disinfectant. Discard your kit components. For frequently asked questions, visit amazondx.com/testing-faq

Wash and dry your hands
Wash your hands with soap and warm water for 20 seconds. Clean the surface of the area where you will collect your sample.
Use hand sanitizer if there is no sink.

Questions?
Frequently asked questions amazondx.com/testing-faq
E-mail: covid19testing@amazon.com

410 Terry Ave N, Seattle, WA 98109

For In Vitro Diagnostic Use Only. For Emergency Use Authorization Only. Rx Only. For Use by Individuals 18 Years or Older.

This product has not been FDA cleared or approved but has been authorized for emergency use by FDA under an EUA for use by authorized laboratories. This product has been authorized only for the detection of nucleic acid from SARS- CoV-2, not for any other viruses or pathogens.

The emergency use of this product is only authorized for the duration of the declaration that circumstances exist justifying the authorization of emergency use of in vitro diagnostics for detection and/or diagnosis of COVID-19 under Section 564(b)(1) of the Federal Food, Drug and Cosmetics Act, 21 U.S.C. § 360bbb-3(b)(1), unless the declaration is terminated or authorization is revoked sooner.