Chronolife CHQ-3-01 Wireless Charger User Guide
- June 6, 2024
- Chronolife
Table of Contents
Smart textile
Monitoring Solution
CHRONOLIFE Wireless Charger
Model: CHQ-3-01
Chronolife Smart Textile – Quick Start Guide ©2021 Chronolife S.A.S
Warning and precautions of us
- This charger is designed for Qi-compatible devices. Nevertheless, we recommend using it only with the Chronolife T-Shirt.
- Do not place metal objects, magnets, magnetic stripe cards, and hard-drive-based devices near the wireless charger. It may cause data corruption.
- Do not attempt to modify, disassemble, or repair this product.
- Do not expose to water, moisture, or extreme temperatures ( below 40 F° or above 90 F°).
Charge the t-shirt’s battery
Please make sure to charge the t-shirt before the application indicates 10% remaining battery. Do not wear the t-shirt while it is charging.
-
Locate the pocket on the outer front of the t-shirt
-
Connect the USB cable to the wireless charger, and then to the power supply
-
Insert the charger inside the pocket and connect the charger to a power outlet
| Charging time | 2-3 hours |
|---|---|
| Battery autonomy | 48 hours |
Chronolife Smart Textile – Quick Start Guide ©2021 Chronolife S.A.S
Regulatory information
Warning
device’s manufacturer can cause an increase in electromagnetic emissions or a
reduction in immunity of the smart shirt and bring about inappropriate
functioning.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:(1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC RF exposure statement:
The equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment.
During the operation of the device, a distance of 15 cm surrounding the device
and 20 cm above the top surface of the device must be respected.
Technical specification
| Coil Diameter | 50mm |
|---|---|
| Input power | 10W 5V – 2V |
| Output | 5W |
| Conversion efficiency | 85% max |
| Working frequency | 115-205 kHz |
| Product standard | WPC v.1.2.4 |
| Protection measures compliant with the WPC standard | FOD, DPL, SCP, Over |
temperature, Over
Chronolife Smart Textile – Quick Start Guide ©2021 Chronolife S.A.S
Smart textile
Monitoring Solution Contact
us:[email protected]
CHRONOLIFE
74 rue du Faubourg
Saint Antoine
75012 Paris, FRANCE
Chronolife Smart Textile – Quick Start Guide ©2021 Chronolife S.A.S