ALTEC IMW1000 HydraMini Everythingproof Wireless Speaker User Guide
- June 6, 2024
- Altec
Table of Contents
ALTEC IMW1000 HydraMini Everythingproof Wireless Speaker
In the Box
A Closer Look
Charging
POWER ON BLUETOOTH PAIRING
SPEAKER CONTROLS
True Wireless Pairing
Turn on the first speaker and connect It with a Bluetooth compatible device.
Turn on the second speaker and
press the button on that speaker.
Press
and hold the button for 2-3 seconds on the first speaker. The first speaker will
now connect to the second so they both play in sync. The Link Buttons will
illuminate green. 
To end TWS press & hold the power button on the speaker.
Voice Assistant/ Reset
To activate Voice Assistant (Siri or Google Assistant)
Disconnect Bluetooth: Press and hold for five seconds and the speaker will beep Reset All connections: Press and hold for ten seconds and the speaker will power off
Overall battery performance varies dependent upon use setting, and
environmental conditions. For further information, please visit
www.alteclansing.com
Light Change Mode
To toggle between the different light modes:
- Multicolor slow transition
- Single color pulse to music
- Multi color pulse to music
- Single color slow fade
- Single color
- Multicolor cycle changed
- Multicolor fast changed with background color
- Multicolor slow fade
- Four color slow fade
- Four color rotation with pulse to music
- Four color rotation
- Off
Press & Hold the button for 1-2 sec to change the Strobe light modes.
- off Pulse to music Blink off *
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment. This
device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
- This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
- This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Sakar International Inc.
195 Carter Drive
Edison, New Jersey 08817, USA
855-292-4087
www.alteclansing.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>