electro-harmonix Tone Corset Analog Compressor/Sustainer Instruction Manual

: June 6, 2024
: electro-harmonix

Table of Contents

BYPASS FOOTSWITCH & STATUS LED
INPUT JACK
AMP JACKThe
CHANGING THE BATTERY
– WARRANTY INFORMATION –

electro-harmonix Tone Corset Analog Compressor/Sustainer

Congratulations on your purchase of the Electro-Harmonix Tone Corset. The Tone Corset is an analog compressor/sustainer that allows for extreme or subtle control of the dynamics of your instrument. There are controls for setting the output volume, sustain/compression, attack, blend amount and pad switch

Note: The TONE CORSET draws up to 9mA at 9VDC with a center negative plug or runs off a 9 Volt battery. If using an adaptor make sure to use one with the correct polarity. Failure to do so may damage your TONE CORSET and void the warranty. Please use an Electro-Harmonix 9.6DC-200mA power supply (same as used by Boss® & Ibanez®: 9.6 Volts DC 200mA) which is sold separately

VOLUME KNOB: Adjusts the output level of the effect
SUSTAIN KNOB: Controls the amount of the compression
ATTACK KNOB: Controls how quickly the compressor will recover .
BLEND KNOB: Adjusts the mix of the dry and compressed signal set to the output
PAD SWITCH: Pads down the input signal to prevent undesirable distortion

BYPASS FOOTSWITCH & STATUS LED

The Footswitch selects whether the Tone Corset is engaged or in True Bypass mode. When the effect is engaged, the LED is lit.

INPUT JACK

The ¼” jack is the audio input for the Tone Corset. The input impedance is 1M.

AMP JACKThe

¼” jack is the audio out for the Tone Corset. The output impedance is 100.

CHANGING THE BATTERY

To change the 9-volt battery, you must remove the 4 screws on the bottom of the Tone Corset. Once the screws are removed, you can take off the bottom plate and change the battery. Please do not touch the circuit board while the bottom plate is off or you risk damaging a component. To extend battery life,ndisconnect the INPUT jack when the Tone Corset is not in use.

– WARRANTY INFORMATION –

Please register online at http://www.ehx.com/product-registration or complete and return the enclosed warranty card within 10 days of purchase. Electro-Harmonix will repair or replace, at its discretion, a product that fails to operate due to defects in materials or workmanship for a period of one year from date of purchase. This applies only to original purchasers who have bought their product from an authorized ElectroHarmonix retailer. Repaired or replaced units will then be warranted for the unexpired portion of the original warranty term.

If you should need to return your unit for service within the warranty period, please contact the appropriate office listed below. Customers outside the regions listed below, please contact EHX Customer Service for information on warranty repairs at info@ehx.com or +1-718-937-8300. USA and Canadian customers: please obtain a Return Authorization Number (RA#) from EHX Customer Service before returning your product. Include with your returned unit: a written description of the problem as well as your name, address, telephone number, e-mail address, and RA#; and a copy of your receipt clearly showing the purchase date.

United States & Canada
EHX CUSTOMER SERVICE ELECTRO-HARMONIX c/o NEW SENSOR CORP.
47-50 33RD STREET LONG ISLAND CITY, NY 11101
Tel: 718-937-8300
Email:info@ehx.com

Europe
JOHN WILLIAMS
ELECTRO-HARMONIX UK 13 CWMDONKIN TERRACE
SWANSEA SA2 0RQ UNITED KINGDOM
Tel: +44 179 247 3258
Email:electroharmonixuk@virginmedia.com

This warranty gives a purchaser specific legal rights. A purchaser may have even greater rights depending upon the laws of the jurisdiction within which the product was purchased.
To hear demos on all EHX pedals visit us on the web at www.ehx.com
Email us at info@ehx.com

Documents / Resources

| electro-harmonix Tone Corset Analog Compressor/Sustainer [pdf] Instruction Manual
Tone Corset, Analog Compressor Sustainer, Tone Corset Analog Compressor Sustainer
---|---