Dongguan Couso Technology CK910B Ultra-Thin Wireless Keyboard Instructions
- June 6, 2024
- Dongguan Couso Technology
Table of Contents
CK910B MANUAL
- Install the battery according to the label ON the battery case ON the back of the keyboard. Flip the switch ON the back of the keyboard to ON (See picture below)
- Open the Bluetooth application on the host and clear the paired Bluetooth keyboard to avoid the same ID: MINI-CK910B;
- Make the Bluetooth keyboard enter the pairing state. Press the ID pairing key, and the pairing indicator blinks(See picture below);
- Enter the Search state for the Bluetooth device on the host site and find the Bluetooth keyboard with the name”Mini-CK910B”Click the searched device and connect it(no password is required for Bluetooth 3.0 or above)
Notice:
- If the keyboard operation is not sensitive, please replace the battery in time.
- Remove the battery if it is not been used for a long time.
Technical parameter
Keyboard input:
FCC Warning: Any Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment. This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>