Hangzhou YajingWei Electronic Technology YJW824B-TX Stroller Remote Control Instructions
- June 6, 2024
- Hangzhou YajingWei Electronic Technology
Table of Contents
Hangzhou YajingWei Electronic Technology YJW824B-TX Stroller Remote
Control
Instruction
- Supply Voltage-DC3.0v,Battery 2*1.SVAAA{not included)
- Frequency 2.40 GHz-2.47 GHz{Peak output power:SdBm)
- Instructions
- First-time use need to match code, this product has memory function Replace battery is unnecessary to match code
- Hold down” S “keys for 3 seconds start match code, The first LED flicker
- Turn on the car body power now, The first LED lit up, Match code Success
- Remoter 10 seconds not run will be standby, Press any key wake up
- Keys caption:” .A. “Forward, 11 T “Back, 11 ◄ “Left, 11 ► “Right, 11 S “Speed,” P” Brake. Press “S” key set up speed,1 led lit up is a low speed,2 LEDs lit up is a medium speed, 3 LEDs lit up is a high speed, Back a car is only low speed Press” P” key hold the brake, All LED flicker
The remote controller only can be used with an adult’s guidance
FCC Statment
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits
fora Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation.This equipment generates, uses and
can radiate radio frequency energy and,if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on,the user is encouraged to try to correct the interference
by one or more of the following
Measures:
- Reorient or relocate the receiving antenna
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Warning: Changes or modifications to this unit not expressly approved by
the part responsible for compliance could void the users authority to operate
the equipment.
FCC Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirements.
The device can be used in portable exposure conditions without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>