Hangzhou Cleesink Mechanical Electrical NYWK-2 Garbage Disposal Self-Powered Wireless Switch Kit Installation Guide

Hangzhou Cleesink Mechanical Electrical NYWK-2 Garbage Disposal Self- Powered Wireless Switch Kit Installation Guide

TYPICAL INSTALLATION

1. Mount Push Button
   
   Peel off the paper on back of the wireless switch, then stick the wireless switch on where you need it or where it is convenient.
   -OR-
   Put the wireless switch on where you need it or where it is convenient without stick.
   -OR-
   Carry the wireless switch directly as you need.

2. Plug in Power Module
   
   Plug power module into a dedicated, grounded 220V/120V AC outlet that is continuously energized.

3. Connect Power Module and Disposer
   
   Plug disposer cord into power module.
   Check all parts have been connected well before using.
   Press and release the wireless switch button to turn the disposer on.
   Press and release again to turn the disposer off.
   

Don’t plug into metal box. Don’t plug close to the ground or metal.

DISCLAIMER: Installation instructions and specifications are provided for general information purposes only. It is subject to change at any time without prior notice to the user. The information in this document should not be construed as a commitment by Hangzhou KeliXun Electrical Co., Ltd.

PARAMETERS

Power Button

Power Light

ATTENTION
Every plug has been preprogrammed. DO NOT Long Press Power Button casually, if you have any problem, please contact us by e-mail: easyishome@hotmail.com

CLEESINK Wireless Switch Kit

• Design for American Standard outlet.
• Adopt newest RFID system, easy to control electrical device.
• 2.4GHz signal works through doors and walls, operates up to 100feet away indoor.
• No batteries required, adopt newest energy harvesting technology.
• Compatible with Garbage Disposals Unit rated power under 1.5 HP.

Warranty

One year replacement warranty.

FCC Radiation Exposure Statement

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.

FCC Warning

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

NOTE 2: Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>