FORTNITE FNT0733 Mudflap RC Vehicle Instruction Manual
- June 6, 2024
- Fortnite
Table of Contents
FORTNITE FNT0733 Mudflap RC Vehicle
CONTENTS
BATTERY INSTALLATION INSTRUCTIONS
ADULT INSTALLATION REQUIRED
MUDFLAP
Move the switch at the bottom of the Mudflap to the OFF mode. Use a Phillips Head screwdriver (not included) to remove the cover.
Remove
the old batteries and insert the new (6 X 1.5V AA Size (LR6)) batteries with
the correct polarity indicated inside the box. Screw the cover back in.
Move
the switch to the ON mode to activate all play features of the Mudflap. Move
the switch to the OFF mode when not in use to help save battery life.
REMOTE CONTROL
Move the switch at the bottom of the Remote Control to the OFF mode. Use a Phillips Head screwdriver (not included) to remove the cover.
Remove
the old batteries and insert the new (2 X 1.5V AAA Size (LR03)) batteries (not
included) with the correct polarity indicated inside the box. Screw the cover
back in. 
Move
the switch to the ON mode to activate all play features of the Mudflap.
Move the switch to the OFF mode when not in use to help save battery life.
HOW TO PLAY
Switch mode from TRY ME to ON at the bottom of the Mudflap for full features.
Do not operate your vehicle on the street or on wet surfaces.
For best results, operate on smooth surfaces and avoid water and other
liquids.
REMOTE CONTROL PAIRING
- Turn the vehicle ON, then turn the transmitter controller ON within 30 seconds.
Do not press any buttons or switches on the controller while pairing, this may cause interference. - The LED light on controller will start blinking.
- Once the pairing is successful, the LED light on controller will stop blinking and stay on.
- If pairing is unsuccessful, turn the vehicle and controller OFF and try again.
NOTE: The vehicle will enter sleep mode after approximately 2 minutes of inactivity. If the vehicle enters sleep mode, turn the vehicle and controller ff, then back on to continue operating with full capabilities.
- RANGE OF PLAY: approx. 80 feet (24 meters).
- CONTROLLER FREQUENCY BAND : 2410 MHz – 2473 MHz,
- MAXIMUM POWER : 0.457mW
- RECEIVER FREQUENCY BAND : 2410 MHz – 2473 MHz,
- MAXIMUM POWER : 0.120mW
ADJUST STEERING ALIGNMENT
If the vehicle doesn’t move forward in a straight direction, adjust the
steering alignment lever on the underside of the vehicle.
FIGURE PLACEMENT
Front of Cab opens to allow easy figure placement. 
SOUND ACTIVATION
Collision sounds activate by pressing front bumper. 
LIGHT ACTIVATION
While turned ON, Mudflap lights will remain illuminated. 
TROUBLE SHOOTING
BATTERY WARNINGS:
- Batteries are to be replaced by an adult.
- Non-rechargeable batteries are not to be recharged.
- Rechargeable batteries are to be removed from the toy before being charged.
- Rechargeable batteries are only to be charged under adult supervision.
- For best performance, only the recommended batteries or their equivalent are to be used.
- Batteries must be inserted with correct polarity.
- Do not mix new and used batteries.
- Do not mix different types of batteries.
- Exhausted batteries are to be removed from the toy.
- The supply terminals are not to be short-circuited.
HOW TO CLEAN MUDFLAP
- TO CLEAN, WIPE WITH A CLOTH.
- DO NOT SUBMERGE IN WATER.
- DO NOT USE CHEMICAL OR ABRASIVE CLEANERS.
FCC Statment
FCC ID for Vehicle: YNIJAZWARES733
FCC ID for Controller: YNIJAZWARES73A
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
WARNING! Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
NOTE : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receive is connected.
- Consult the dealer or an experienced radio/TV technician for help.
WARNING : This toy produces flashes that may trigger epilepsy in sensitised individuals.
WARNING! All of the packaging, such as tape, plastic sheets, wire ties,
stickers and tags, are not part of this product. Please discard for your
child’s safety. Retain package for future reference as it contains important
information.
Conforms to toy safety standards CPSIA, ASTM-F963 and EN71.
Product appearance and colors may vary from shown.
Made in China
Used with permission. Manufactured and Distributed by: Jazwares, LLC, Sunrise,
FL 33326, USA
Jazwares, 16A Crane Grove, London, N7 8LE, United Kingdom Jazwares GmbH, Mina-
Rees-Str. 8, 64295 Darmstadt, Germany
www.jazwares.com /
www.jazwares.de
© 2021 Epic Games, Inc. Fortnite and its logo are trademarks of Epic Games,
Inc. in the USA (Reg. U.S. Pat. & Tm. Off.) and elsewhere.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>