Targus AMW584 Bluetrace Wireless Mouse User Guide
- June 6, 2024
- Targus
Table of Contents
Targus AMW584 Blue trace Wireless Mouse
Functional Introduction
- Left button
- Right button
- Scrolling Wheel
- Forward
- Backward
- ZOOM Key
- DPI Switch Key (LED Indicator)
- Battery status LED Indicator
- Win Key
- Nano Receiver
- Battery Cover
- Connect Button
- ON/OFF Switch
DPI Switch
The LED indicator under tilt wheel will light up when you plug the mouse into the USB port. The brightness of the indicator indicates the DPI setting in use. There are three different settings:
- Bright: 1600 DPI
- Dim: 1300 DPI
- No light: 800 DPI
The default setting is 800 DPI. You can easily switch between DPI settings. In order to save power, the LED display will only last for 10 seconds.
Contents
- Targus Wireless Mouse
- 2 x AA Energizer Battery
- USB Receiver
- User Guide
System Requirements
- Windows® 10
- macOS®
- iOS®
- Android™
Forward
Press this button to view the next page in your Internet browser.
Backward
Press this button to view the previous page in your Internet browser.
Zoom Key (Zoom in/out)
Press zoom key + scroll to zoom in/out.
Win Key
Windows button for one-touch access to the Start screen.
AMW584
2.4G Frequency Range| 2408MHz–2474MHz
Battery Type| 2*AA battery
Effective 2.4G RF Communication Range| 10 metres max.
2.4G Maximum EIRP Power (dBm) (EU)| 2.2dBm
Rating| 3V 100mA
AMW584R
2.4G Frequency Range| 2408MHz–2474MHz
Interface| USB 1.1 / 2.0
2.4G Maximum EIRP Power (dBm) (EU)| -0.2dBm
Rating| 5V 100mA
Installing the batteries
Step 1: Take the battery cover off.
Step 2: Insert the batteries as shown inside the battery compartment.
Step 3: Replace the cover.
Step 4: Turn on power switch.
Warning:
Please insert the battery with the correct position according to the instruction labeled on the mouse.
Step 5: If you need to travel with your wireless mouse, made sure you turn off the POWER SWITCH.
Setup the Connection between the Receiver and the Mouse
- Insert the batteries into the mouse, then follow the steps below.
- In the meantime, to open the mouse under the cover, take the nano receiver out.
- Plug the Nano receiver into the USB A port on your computer.
- If the mouse does not work, please put it into pairing mode.
- Pairing: Re-plug the receiver into the USB port on your computer, then press the connect button on the mouse. If the mouse does not work after 10 seconds, pair them again. (The receiver has auto pairing function).
- The LED indicator on mouse flashes steadily when it is in pairing mode and stops blinking when it is successfully paired with the receiver.
- When low battery, the battery indicator on the mouse will start to blink.
Power status LED Indicator
Power ON| LED is on for 5 seconds
Wake up| LED is on for 5 seconds
Low battery| LED blinks 10 seconds
Battery status LED Indicator
3 LED Bright| 80~100%
2 LED Bright| 50~70%
1 LED Bright| 20~40%
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>