SOLTECH SUNDIAL 3W Solar Bollard Light Installation Guide
- June 6, 2024
- SOLTECH
Table of Contents
SOLTECH SUNDIAL 3W Solar Bollard Light
Introduction
Thank you for purchasing SUNDIAL Solar Bollard Light.
Important
Please read these instructions before installation to ensure optimum results
and longevity of your lights. The solar panel should be charged in full
sunlight for 8 to 9 hours before initial first use to provide optimum results.
Features
- Full 360 degree design to track full solar trajectory
- Three heights to meet various site planning needs
- No trenching, wiring, nor electricity costs
- IK10 impact rating on PC cover
Notice & Warning
- The SUNDIAL will provide optimum performance where there is enough sunshine.
- Please note that the duration of illumination depends on sunshine exposure and weather.
- The lamp will automatically turn on at dusk.
- Disassembling the fixture head voids the product warranty.
- The battery contains hazardous chemicals. Please dispose of used batteries properly.
Please Note
Continuous rain or cloudy days will not fully charge the battery, so the
light’s output length will decrease.
Specification
Specifications| SUNDIAL 3W 13“| SUNDIAL 3W 24”| SUNDIAL 3W
42“
---|---|---|---
LED Nominal Power| 3W
Solar Panel| Mono-Crystalline 4.3V 3W
Lithium Ion Battery| 3.7V 10AH
CCT| 3,000K
Lumen Output@3000K| 300
CRI| 70
Light Head| 8.4 X 8.0 Inches
Ground Mount| 13 Inches| 24 Inches| 42 Inches
Beam Angle| 217°
IP Rating| IP65
Casting| PC & Aluminum
Efficiency@3000K| 100 lm/W
Charging Time| 14hrs (1000W/m2)
Run Time (@Full Power)| 48 Hrs
Operation Mode| 1 Mode
Operating Temperature| -4 °F to 130 °F
*** Charging Temperature**| 5 °F to 140 °F
Installation
GROUND MOUNT
- Drill three holes in the base material, then use the screw kit to secure the ground mount base.
- Use the screw kit to fix the pole onto the ground mount base.
- Press the red button on the bottom of the fixture to turn it on.
- Use the screw kit to fix the light onto the pole.
- When installing the ground mount base, please put Part A and Part B into the ground holes first then install the ground mount base on top.
WALL MOUNT
- Drill three holes on the base of the existing surface then use the screw kit to secure the wall mount base.
- Use the screw kit to fix the pole onto the wall mount base.
- Press the red button on the bottom of the fixture to turn it on.
- Use the screw kit to fix the light onto the pole. When installing the wall mount base, please put
- Part A and Part B into the surface holes first then install the wall mount base on top.
Light Distribution
Warranty
SUNDIAL is covered by a 3 year limited warranty. SOLTECH urban light warrants to the original purchaser that this product is free from defects in materials and workmanship for the period of 3 years from date of purchase. To obtain warranty service please contact your local distributor or sales rep for further instruction.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>