Ecolink CS-902 ClearSky Chime + Siren User Guide
- June 6, 2024
- Ecolink
Table of Contents
Ecolink CS-902 ClearSky Chime + Siren
Thanks for choosing Ecolink’s ClearSky Chime + Siren. You’ve made a sound investment!
Pair your ClearSky CHIME+SIREN with your ClearSky Bridge
Configuring Sound EffectsThe ClearSky Bridge features different sounds you can use for the following events:
- Chime Notifications
- Alarms
- Entry Delay
- Exit Delay
- Security Modes
To configure your Chime+Siren to use different sound effects for chimes or alarms, please scan the QR code below for additional instructions.
Custom
sound effects
The ClearSky Chime+Siren features a microSD input to allow you to play your
own custom sounds.
Custom sounds
To configure your Chime+Siren to use custom sound effects, please scan the QR
code below for additional instructions.
Default Sound Effects
These are the default sound effects included with your Chime + Siren
- Chime 1
- Chime 2
- Chime 3
- Chime 4
- Chime 5
- Chime 6
- Chime 7
- Chime 8
- Chime 9
- . Chime 10
- Chime 11
- Chime 12
- Alarm Siren 1
- Exit Delay
- Entry Delay
- Smoke Alarm
- CO Alarm
- Armed Away
- Armed Home
- Disarmed
- Front Door
- Side Door
- Back Door
- Garage Door
- Alarm Siren 2
- Alarm Siren 3
- Doorbell 1
- Doorbell 2
- Doorbell 3
- Doorbell 4
For more support, please go to www.EcolinkClearSky.com
CS-902 ClearSky Chime+Siren
Specifications
Frequency: 345MHz & 2.4 GHz Power: 120VAC, 60Hz, 0.25A Max US Decibel Rating: 105 dB @ Max Volume
Operating Temperature: 32°-120°F Operating Humidity: 5-95% RH Indoor Use Only
The ClearSky Chime+Siren will play designated Chime and Siren sound effects
when used with a ClearSky Bridge. To test the Chime+Siren, power the device on
and press the volume buttons on the side to verify functionality.
FCC ID: XQC-CS902 IC: 9863B-CS902
FCC Compliance Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
-
This device may not cause harmful interference, and
-
this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for Class B digital devices, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -
Re-orient or relocate the receiving antenna
-
Increase the separation between the equipment and receiver
-
Connect the equipment to an outlet on a different circuit from the receiver
-
Consult the dealer or an experienced radio/TV contractor for help.
Warning:
Changes or modifications not expressly approved by Ecolink Intelligent Technology Inc. could void the user’s authority to operate the equipment.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>