filesusr What do the LED Light Colors indicate? User Manual
- June 6, 2024
- filesusr
Table of Contents
filesusr What do the LED Light Colors indicate?
User Manual
IMPORTANT: Please connect your hotspot to the Internet via Ethernet the first time it is powered up so that it will receive the latest OTA before you connect it to the Helium app via Bluetooth.
| DO | DON’T | DIAGNOSER |
|---|
Place Miner Indoor
Opt to Use Ethernet for Connection Stability
Gently Screw on the Included Stock Antenna
Connect Antenna First Before Power on Hotspot| Put Miner Outside in Heat/Cold
Install Upgraded Antenna
Directly to Connector
Reboot the Miner Excessively
Turn the Miner Around the Antenna Cable
Open the Hotspot| View Helium & Bobcat Firmware
Check Real-Time Miner
Syncing Information
Reboot/Reset/Resync/Fast Sync
User Guide
https://www.bobcatminer.com/post/bobcat-diagnoser-user-guide
What do the LED Light colors indicate?
Red: Hotspot is booting.
Yellow: Hotspot is powered on but Bluetooth is disabled, and it’s not
connected to the internet.
Note: You should contact customer support if the LED light is consistently
yellow for days, yet your internet connectivity is stable. Check your internet
connectivity if the LED light switches between yellow and green consistently.
Do not worry if the LED light is temporarily yellow, but can turn back to
green on its own.
Blue: In Bluetooth mode. Hotspots can be detected by the Helium app.
Green: Hotspot is successfully added onto the People’s Network, and it’s
connected to the internet.
My miner is connected to the Internet, but sometimes I still see the LED
light change from green to yellow. Do I need to reboot?
No. If you are certain that internet connectivity is stable, you do not have
to do anything.
The light will go back to green on its own.
I want to switch from wifi to ethernet connection. How do I switch
properly?
To ensure your miners are connected via ethernet: (1) Unplug the miner; (2)
Insert the ethernet cable into the correct port on the miner; and (3) Plug the
power cable back into the miner. It should now connect via ethernet instead of
WiFi.
Bluetooth is turned on, but the hotspot cannot be found.
Turn off your cell phone’s Bluetooth and unplug the power adapter. Wait for a
minute and start over.
The Bluetooth button was held down as instructed, but the LED does not
change to blue.
Using the pin to press through the BT button can sometimes be tricky. Make
sure the pin is positioned on the button for five seconds. If it does not
work, unplug the power adapter, wait for a minute, and start over.
Need More Help?
Please use your phone’s camera to scan the qr code and complete our customer
support form.
https://www.bobcatminer.com/contact
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>