GE current IND437 Lumination Tela Mini Hexcel Louver Accessory Installation Guide
- June 6, 2024
- GE current
Table of Contents
GE current IND437 Lumination Tela Mini Hexcel Louver Accessory
FOR USE WITH CEILING MOUNTED TRACK ONLY.
READ TRACK MANUFACTURER’S INSTALLATION INSTRUCTIONS FOR GUIDELINES ON TRACK
INSTALLATION.
WARNING
RISK OF ELECTRIC SHOCK
Turn power off before inspection, installation or removal.
WARNING
RISK OF ELECTRIC SHOCK
Turn power off before inspection, installation or removal.
SKU
| Material Description| Product Description
---|---|---
93026696| LTMHX| LTM HEXCEL LOUVER
IMPORTANT SAFETY INSTRUCTIONS
When installing or using this track system, basic safety precautions should always be followed, including the following:
- Read all instructions
- Do not install this track in damp or wet
- Do not cut any track
- Do not install any part of a track system less than 5 feet above the floor.
- Do not install any luminaire assembly closer than 6 inches from any curtain, or similar combustible material.
- Disconnect electrical power before adding to or changing the configuration of the track.
- Do not attempt to energize anything other than lighting track luminaires on the track. To reduce the risk of fire and electric shock, do not attempt to connect power tools, extension cords, appliances, and the like to the
- Do not connect a track to more than one branch circuit unless the track is constructed so that it can be used with more than one branch circuit. Check with a qualified electrician. Although the track lighting system may seem to operate acceptably, a dangerous overload of the neutral may occur and result in a risk of fire.
SAVE THESE INSTRUCTIONS
For future reference when adding fixtures or changing the track configuration.
Installation of Hexcel Louver on the Tela Mini Series Track Light
- Begin with fixture disconnected from the track.
- Unscrew the top of the fixture and remove the cap and black plastic accessory ring.
- Place the hexcel louver inside the accessory ring, so that it sits evenly inside the ring. If the LTM fixture is equipped with Whiter White, the glass lens should sit on top of the louver.
- Place the accessory ring back inside the cap with the louver outermost in the assembly.
- 5 Screw the cap back onto the fixture.
www.gecurrent.com
© 2022 Current Lighting Solutions, LLC. All rights reserved. GE and the GE
monogram are trademarks of the General Electric Company and are used under
license. Information provided is subject to change without notice. All values
are design or typical values when measured under laboratory conditions. IND437
(Rev 01/25/2022)
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>