MORE BYO Router Setup FTTP Connections User Manual
- June 6, 2024
- more
Table of Contents
MORE BYO Router Setup FTTP Connections
Step 1
Locate the NBN Connection Box that has been
installed inside your property.
Step 2
Gently lift the cover of the NBN Connection Box. To do this press the two
clips on either side and lift the cover at an angle.
Step 3
Ensure that the power cable is securely in place and that the Power and
Optical lights are showing as steady green on the Connection Box.
Step 4
Now look on the under side of the NBN Connection Box where you can see the
Uni-D ports surrounded by yellow.
Step 5
Connect a computer or laptop to your BYO router via a cable or by WIFI and access the router configuration page. If you are unsure how to do this, please consult the router user guide.
Step 6
Most routers will provide a Quick Start Guide or Setup Wizard – please try and
follow these steps. Ensure that your router is configured in WAN mode and
encapsulation is set to PPPoE. On most devices you should leave all other
settings as default. Then configure your BYO router using the ISP username and
password that we will have emailed and SMS’d to you.
Due to the number of router brands available it is hard to give precise setup
information here. We recommend consulting your router user guide or speaking
to the manufacturer of your device.
Step 7
After you have successfully configured your BYO router please wait a couple of
minutes for it to connect to the network. After a couple of minutes you should
see the authentication light on the router become lit and steady (not
flashing). The authentication light is often labelled ‘Internet’ or ‘www’ or
‘Web’. Please consult your router user guide if you are unsure which light is
the authentication light.
Troubleshooting
| Symptom | Things to try |
|---|---|
| Optical light on the NBN box is red | You will need to contact our team |
in this instance, and we may need to log a
fault with NBN.
www or internet light does not come on on your router
| 1. Ensure that the router is in PPPoE mode and has been correctly configured with the ISP username and password. Triple check for any spelling mistakes or typos.
2. Ensure that you are connected to the correct Uni-D port on the NBN box.
3. Try an alternative network cable to connect your router to the NBN box.
4. Ensure that the router is configured in WAN mode.
UNID Light is OFF
| 1. Ensure that the network cable is properly plugged in from the WAN port of
the router and into the assigned UNID port of the NBN box.
2. Try an alternative network cable to connect your router to the NBN box.
3. Turn the power off to the NBN Connection Box by unplugging the power cable for 10 seconds and turn it back on. Wait for 3 minutes and see if the UNID light is on
Technical Support
If you require assistance setting up your BYO device our team is available.
7am – Midnight (Weekdays) AET 8am – 8pm (Weekends) AET Phone: 1800 733 368
Live Chat: www.moretelecom.com.au WhatsApp: +61480096696 Overseas: +61390219630
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>