TRENDNET TPE-2840WS 28-Port Gigabit Web Smart PoE+ Switch Installation Guide
- June 6, 2024
- TRENDnet
Table of Contents
Quick Installation Guide
PoE Web Smart Switch Series
UL Warning
- Elevated Operating Ambient Temperature – If installed in a closed or multi- unit rack assembly, the operating ambient temperature of the rack environment may be greater than room ambient. Therefore, consideration should be given to installing the equipment in an environment compatible with the manufacturer’s maximum rated ambient temperature (Tamra).
- Reduced Air Flow – Installation of the equipment in a rack should be such that the amount of airflow required for the safe operation of the equipment is not compromised.
- Mechanical Loading – Mounting of the equipment in the rack should be such that a hazardous condition is not achieved due to uneven mechanical loading.
- Circuit Overloading – Consideration should be given to the connection of the equipment to the supply circuit and the effect that the overloading of circuits might have on overcurrent protection and supply wiring. Appropriate consideration of equipment nameplate ratings should be used when addressing this concern.
- Reliable Earthing – Reliable earthing of rack-mounted equipment should be maintained. Particular attention should be given to supply connections other than direct connections to the branch circuit (e.g., use of power strips).
Rack Installation
The Switch can be mounted in an EIA standard, 19-inch rack, which can be
placed in a wiring closet with other equipment. To install, attach the
mounting brackets on the switch’s front panel (one on each side) and secure
them with the screws provided.
Attaching the mounting
brackets to the Switch
Use the screws provided with the equipment rack to mount the Switch on the
rack.
Installing the Switch in an equipment rack
Certifications
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received. Including interference
that may cause undesired operation.
****Waste electrical and electronic products must not be disposed of with household waste. Please • recycle where facilities exist. Check with your Local Authority or Retailer for recycling advice.
FCC warning:
This equipment has been tested and found to comply with the limits for a Class
A digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own expense.
FCC Caution:
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate this equipment.
CAUTION: Double pole, neutral fusing. Disconnect mains before servicing.
ATTENTION: Double pole/fusible sur le neutre.
Technical Support
If you have any questions regarding the product installation, please contact
our Technical Support. Toll-free US/Canada-
1-855-373-4741 Regional phone numbers
available at www.trendnet.com/support
TRENDnet
20675 Manhattan Place Torrance, CA 90501 USA
Applies to PoE Products Only: This product is to be connected only to PoE
networks without routing to the outside plant.
Note
The Manufacturer is not responsible for any radio or TV interference caused by
unauthorized modifications to this equipment. Such modifications could void
the user’s authority to operate the equipment.
**Fiber product warning note:**
If the Optical Transceiver doesn’t ship with the unit, the user manual shall
have the description as below or equivalent: “This product is intended to be
used with a UL Listed Optical Transceiver product, Rated DC3 3V, Laser Class
I.” Laser warning note: This product is intended to be use with a UL Listed
Optical Transceiver product, Rated DC3.3V, Laser Class I.
Product Warranty Registration
Please take a moment to register your product online. Go to TRENDnet’s website
at: www.trendneLcom/register
Copyright C. 2021. All Rights Reserved. TRENDnet.
PoE Web Smart Switch Series / 06.16.2021
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>