TRENDNET TEG-S51, TEG-S83 5 Port, 8 Port Gigabit Desktop Switch Installation Guide

TEG-S51, TEG-S83 5 Port, 8 Port Gigabit Desktop Switch
Installation Guide

Note: The switch may be different than the one shown in the examples.

Note: Verify the switch’s LEDs are working properly. Please see the table below:

Declaration of Conformity

Manufacturer’s Name and Address
TRENDnet, Inc.
20675 Manhattan Place
Torrance, CA 90501 USA
Zwolsestraat 156 2587 WB
The Hague The Netherlands

Product Information:
Model Number: TEG-S51 / TEG-S83
Product Name: 5-Port Gigabit Desktop Switch 8-Port Gigabit Desktop Switch
Trade Name: TRENDnet
TREND net hereby declares that the product is in compliance with the essential requirements and other relevant provisions under our sole responsibility.

Safety EN 62368-1:2014+A11:2017
EMC EN 55032:2015+A11:2020
EN 61000-3-3:2013+Al:2019
EN IEC 61000-3-2:2019
EN 55035:2017+A11:2020

This product is herewith confirmed to comply with the Directives.
Directives:
EMC Directive 2014/30/EU
RoHS 3 Directive 2015/863/EU
RoHS Directive 2011/65/EU
WEEE Directive 2012/19/EU
REACH Regulation (EU) No. 1907 /2006
Low Voltage Directive 2014/35/EU
Person was responsible for this declaration.
Place of Issue: Torrance, California, USA
Date: February 03, 2022
Title: VP of Technology
Name: Sonny Su
Signature:

Limited Warranty

TRENDnet warrants its products against defects in material and workmanship, under normal use and service. Specific warranty periods are listed on each of the respective product pages on the TRENDnet website.

Wall-mounted instructions
The Unit has two wall-mount slots on its bottom panel.
Before you begin, make sure you have two screws that indicate a diameter measurement of 0.1377 inches (4.0mm).

1. Determine where you want to mount the switch.
2. Drill two holes into the wall. Make sure adjacent holes are 4.51 inches (114 mm) apart.
3. Maneuver the switch so the wall-mount slots line up with the two screws.
4. Place the wall-mount slots over the screws and slide the switch down until the screws fit snugly into the wall-mount slots.
5. Screw type T3 x 15mm x 2
   The equipment power supply cord shall be connected to a socket-outlet with earthing connection.

Certifications
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference.
2. This device must accept any interference received. Including interference that may cause undesired operation.

Technical Support
If you have any questions regarding the product installation, please contact our Technical Support.
Toll-free US/Canada: 1-866-845-3673
Regional phone numbers available at www.trendnet.com/support
TRENDnet
20675 Manhattan Place
Torrance, CA 90501
USA

Waste electrical and electronic products must not be disposed of with household waste. Please recycle where facilities exist.
– Check with your Local Authority or Retailer for recycling advice.
Applies to PoE Products Only: This product is to be connected only to PoE networks without routing to the outside plant.
Note
The Manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user’s authority to operate the equipment.
Product Warranty Registration
Please take a moment to register your product online.
Go to TRENDnel’s website at: www.trendnet.com/register

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>