AKRAPOVIC BMW M340i Exhaust System Sound Kit Instruction Manual

June 6, 2024
akrapovic

AKRAPOVIC BMW M340i Exhaust System Sound Kit Instruction Manual
AKRAPOVIC BMW M340i Exhaust System Sound Kit

SAFETY AND COMPLIANCE WARNING, PLEASE READ CAREFULLY

BEFORE REMOVING THE STOCK EXHAUST SYSTEM AND BEGINNING THE INSTALLATION OF YOUR NEW AKRAPOVIČ EXHAUST, PLEASE MAKE SURE THAT ALL ITEMS LISTED BELOW ARE VERIFIED:

  • This manual is specific to the car indicated on the cover page, for which it is designed. Installation procedures vary depending on the type of car. Please verify that the Akrapovič exhaust system and this installation manual correspond to the type of your car.
  • The exhaust system can get extremely hot during and after it is used. Make sure not to touch the exhaust system until it is completely cool. Allow the exhaust and engine to cool down before beginning installation.
  • Make sure the car is securely positioned to prevent damage to yourself and other, or the car.
  • Please check the parts you received against the parts list available on our  website (please use the QR code on the front page or look for “schematic view” in the respective product page on www.akrapovic.com). Make sure that you have all the parts necessary for the installation of your new Akrapovič exhaust system. If any of the parts is missing, please do not proceed with uninstalling your stock exhaust system/installing the Akrapovič exhaust system and contact the retailer where you purchased the Akrapovič exhaust system.
  • Every exhaust system muffler has its unique serial number, which identifies the authenticity of the product. You can find the serial number on the muffler’s sleeve. Please refer to the picture 1 below. Please verify that your exhaust system is an original Akrapovič product. If you have any doubts, please contact the reseller where you purchased the exhaust system or Akrapovič partners. This manual, any certificates and Akrapovič warranty apply to original products only

GENERAL NOTE

Photographs and other illustrations in this manual are symbolic and are intended to help represent individual steps for proper installation and use, as well as for a general overview. The actual component parts of the Akrapovič exhaust system may not entirely correspond to the photographs and other illustrations.

Picture 1 – Serial Number Position

Serial Number Position

NOISE AND EMISSION WARNINGS

General warning
Because of the world-wide distribution of Akrapovič d.d. products, neither Akrapovič d.d. nor any of its subsidiaries make any representation that the exhaust system complies with the air and/or noise emissions laws, or labeling laws, of any jurisdiction. The purchasers are entirely  responsible for informing themselves of the applicable laws where the products are to be used and to comply with those law.

Although legal compliance of Akrapovič products in a specific country should be determined by the user, you can find some basic guidance on compliance of your Akrapovič exhaust system with various legal requirements on the product- related part of our website (please use the QR code on the front page or look for the respective product page on www.akrapovic.com). For EC and ECE type approvals, please refer to the certificate enclosed to your product

USA WARNING

Various U.S. states and the U.S. federal government have individual laws regulating the use of aftermarket exhaust parts and systems, especially as those parts and systems modify, remove, or replace original equipment catalysts. Please consult the appropriate laws in your area before installing any aftermarket part or system on your vehicle to ensure compliance with all applicable laws. Neither Akrapovic d.d. nor any of  their subsidiaries or the sellers of the parts or systems make any representation that any of their parts or systems comply with any such laws

CALIFORNIA WARNING

California laws prohibit the use of any aftermarket exhaust part or system that modifies, removes or replaces original equipment catalysts unless the California Air Resources Board has issued an Executive Order regarding such part or system or unless the part or system is exempted by being used only on racing vehicles on closed courses. Neither Akrapovic d.d. nor any of their subsidiaries make any representation that any of their parts or systems has received such an Executive Order or that any of their parts or systems conform with the racing vehicles exemption. The purchasers are entirely responsible for informing themselves of applicable California laws and to comply with those laws

SYMBOLS

The following symbols are used throughout these installation instructions:

  • Tool icon TOOLS AND PROTECTIVE EQUIPMENT REQUIRED

  • Drop icon LUBRICATION

  • IconINSTALLATION TIP

  • TIGHTENING TORQUE

  • HAND TIGHTEN’

  • CAUTION OR IMPORTANT

  • USE BOLT SEALANT
    Apply 3 to 4 small drops of bolt sealant onto the cleaned and degreased threads before tightening the bolts.
    WARNING! Avoid contact with skin, eyes and mucous membranes. Do not inhale fumes. Keep out of reach of children

  • USE ANTI-SEIZE LEAD-FREE COPPER PASTE (black tube)
    Provides trouble-free and long-lasting protection against seizing, corrosion and rusting of bolts, threaded ends, nuts, joints, etc. Also protects against vibration, wear and impact.
    WARNING! Avoid eye contact. Keep out of reach of children.

  • USE ANTI-SEIZING GREASE (white tube)
    Prevents seizing, corrosion and excessive wear between the titanium components of your exhaust system. WARNING! Avoid eye contact. Keep out of reach of children.

Tools & equipment 

Tools & equipment 

  • mechanic gloves
  • eye protection
  • Torx 20
  • Torx 40
  • T-handle 8 mm wrench
  • T-handle 10 mm wrench
  • Flat screwdriver
  • Small cross head screwdriver
  • Cutting nippers

PARTS LIST

The following parts should be found in the box:

  • Installation Manual
  • Homologation certificate/ compliance documents if applicable
  • Warranty
  • Fitting material
  • Muffler, pipes, Carbon Fiber components or Sound Kit components

Detailed list of parts can be found on the Akrapovič website (please use the QR code on the front page or look for “Schematic view” in the respective product page on www.akrapovic.com).

IMPORTANT: The car should be in the off position throughout the dismounting and installation process, as well as any other work done on the exhaust system!

REMOVAL OF STOCK EXHAUST SYSTEM

The process of uninstalling the original exhaust system may vary depending on the existing exhaust system. Please follow the original exhaust system manufacturer’s instructions for uninstalling the original exhaust system.

If you for any reason decide otherwise, please note that any information provided in this respect herein should be considered as general information provided for your convenience only. Akrapovič shall not assume any liability or responsibility with regard to uninstalling your existing exhaust system, warranty coverage of such exhaust system or vehicle or their further fitness for use.

In case your Akrapovič exhaust system may not be used on certain roads or under certain conditions, please keep the stock or other exhaust system that you can use in such circumstances legally.

INSTALLATION OF THE AKRAPOVIČ SOUND KIT

  1. Open the trunk, remove the trunk floor panel, loading sill cover and left trunk trim panel, to get access to Akrapovič Control Kit; check the Akrapovič Slip-On exhaust system installation manual for details (F 01).
    CAUTION: make sure not to injure yourself or damage any part of the vehicle during this process!

  2. The Sound Kit components (F 02):
    Installation Instruction

  3. Sound Kit receiver 1

  4. Remote Controller

  5. Attach the Sound Kit receiver as shown and secure the connecting cable, using tie wraps from Akrapovič installation kit (F 03, 04).
    CAUTION: make sure not to damage any part of the vehicle during this process!

Installation Instruction

  1. Connect the Sound Kit receiver to the Controller TNG unit (F 05).
    CAUTION: make sure not to damage the Sound Kit, Control Kit or any part of the vehicle during this process!
    Installation Instruction

  2. Reassemble the trunk trim in reverse order; check vehicle manufacturer manual for correct procedures (F 06).
    IMPORTANT: check the User Manual provided in the installation kit for correct Remote Controller usage!

FINAL INSTALLATION

IMPORTANT: reinstall the dismounted or partially removed stock parts (wheel arches, bumper etc.); check vehicle manufacturer manual for tightening torques.

IMPORTANT: make sure all the nuts and bolts are sufficiently tightened. In case the exhaust system touches the cowling or other parts, repeat the adjustment of the  exhaust system or contact your authorized dealer.

IMPORTANT: clean all exhaust components before the first start of the engine or the stains will burn onto the surfaces!

MAINTENANCE OF THE AKRAPOVIČ EXHAUST SYSTEM:

  1. lean the titanium exhaust components with a multi-purpose spray lubricant (WD-40® or equivalent)*, carbon fiber exhaust components with soft and dry cloth and  stainless steel components with soft cloth sprayed with contact cleaner, then wipe with soft and dry cloth. A change in the color of the exhaust system is normal due to high temperatures.
  2. Periodically make sure all the bolts and springs are sufficiently tight. *WD-40® is a trademark of the WD-40 Company

INSTALLATION TIP: IT IS NORMAL FOR WHITE SMOKE TO COME OUT OF THE MUFFLER AT FIRST OPERATION.

CAUTION: DO NOT STAND BEHIND THE MUFFLER AT ANY TIME.

CAUTION: DO NOT USE AUTOMOTIVE WHEEL CLEANERS OR ANY CLEANING PRODUCTS WHICH CONTAIN ACIDIC ADDITIVES TO CLEAN THE AKRAPOVIČ EXHAUST SYSTEMS.

WARNING: THE EXHAUST SYSTEM CAN BE EXTREMELY HOT. ALLOW THE EXHAUST AND EN INE TO COOL DOWN BEFORE BEGINNING INSTALLATION OR  ANY OTHER WORK ON THE EXHAUST SYSTEM. THIS MANUAL IS SPECIFIC TO THE BMW  X5M TYPE F95. THERE MAY BE SOME DIFFERENCES IN INSTALLATION PROCEDURES FOR OTHER MODELS.

TROUBLESHOOTING

Problem Possible cause Solution
Remote Controller not working (red blinking then withe blinking Pairing
process not successful Do again the pairing process – check user manual
White LED blinking on the Sound Remote Controller No communication with the
receiver While pressing on the Remote Controller, check if the green LED of

the Sound Kit Receiver is green. If yes, then try to put the Sound Kit receiver in another position.
Red LED blinking on the Sound Remote Controller| There is communication with the receiver but there is some issue with the valve system| Switch off the car. Wait one minute and switch on the car.

DECLARATION OF CONFORMITY OF CONTROLLER TNG

COMPANY: Akrapovič d.d.
ADDRESS: Malo Hudo 8a 1295 Ivančna Gorica, Slovenia

declares that the following products:

Product name: Controller TNG
Trade Name: Akrapovič
Type or model: P-AE100

is in conformity with the requirements of the following Directives of the European Union: Regulation UN/ECE-R10 rev6

Icon10R -06 1323

FCC NOTICE

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.  Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

You can view your product’s FCC Declaration of Conformity (DoC) to the FCC 47 CFR Part 15,
SubpartB, at: http://www.akrapovic.com/docs/ControllerTNG/FCCCertification.pdf.

European Union Directives Conformance Statement

Akrapovič d.d. hereby declares that this Akrapovič Controller TNG P-AE100 is in compliance with the essential requirements and other relevant provisions of Directive 2014/30/EU

You can view your product’s Declaration of Conformity (DoC) to Directive 2014/30/EU (to EMC
Directive) at: http://www.akrapovic.com/docs/ControllerTNG/CECertification.pdf.

Industry Canada compliance statement

This Class B digital apparatus complies with Canadian ICES-003. This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:

  1. this device may not cause interference, and
  2. this device must accept any interference, including interference that may cause undesired operation of the device

European Union Directives Conformance Statement

Atlan d.o.o. hereby declares that this Atlan Communication Detector VTS CAN SNIFFER is in compliance with the essential requirements and other relevant provisions of Directive 2004/108/EU

You can view your product’s Declaration of Conformity (DoC) to Directive 2004/108/EU (to EMC
Directive) at http://www.akrapovic.com/docs/CanSniffer/CECertification.pdf.

QR Code

https://www.akrapovic.com/api/producturl?sapId=129231

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

akrapovic User Manuals

Related Manuals