ALTEC MZX4100 3-in-1 Kid Safe Headphone User Guide
- June 6, 2024
- Altec
Table of Contents
ALTEC MZX4100 3-in-1 Kid Safe Headphone User Guide
In the Box
A Closer Look
Charging
Bluetooth Pairing
Listening to Music
Sharing Connector
Plug the included 3.5mm AUX cable into the AUX IN port. Doing so will
disconnect the headphone’s Bluetooth connection.
Sharing Connector with learning MIC
Plug the included Learning MIC into the sharing connector to listen music and
make and receive phone calls.
Bluetooth Mode with Learning MIC
While in Bluetooth mode, plug the included learning MIC into the Learning MIC
port. This will allow clear communication while learning or working remotely.
For additional user materials and warranty information, please visit alteclansing.com
” The Bluetooth® word mark and logos are registered trademarks owned by the Bluetooth SIG, Inc. and any use of such marks by AL Infinity, LLC. is under license. Other trademarks and trade names are those of their respective owners.”
FCC Statement
This device complies with the part 15 of the FCC rules.Operation is subject to the following two conditions:(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Caution: changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class 3 digital device, pursuant to Part 15 of the FCC Rules.These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with instructions may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on. The user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or experienced radio/TV technician for help.
Radiation Exposure Statement The device has been evaluated to meet general RF exposure requirement in portable exposure conditior without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>