RAFFEL BP536 Battery Pack for Motion Furniture Installation Guide

Table of Contents

RAFFEL BP536 Battery Pack for Motion Furniture image

RAFFEL BP536 Battery Pack for Motion Furniture fig 1

Check the status of the battery while it is in use by pressing the Test Button on the side of the battery pack. The Test LED Indicator status will be displayed for 2seconds.
GREEN LED : the battery has enough power to properly operate the furniture.
RED LED : the battery pack needs to recharge.
If the Test LED Indicator is red, connect the AC Power Supply Cord to the battery pack and plug into a wall outlet for charging.
Operating the battery while charging is permitted, but may require a longer charging time before the battery is fully charged.
While charging, the Charge LED Indicator will remain on to show the charging status.
RED LED: Battery is charging.
GREEN LED : Battery is fully charged.
For a healthy battery: Unplug the battery from the wall outlet once it is fully charged.
Do not allow the battery to completely drain as this may reduce the life of the battery.
Allow for 7 hours of charging for the battery to be fully charged.

Problem:
No Power Output
from Battery Pack

Check connections between the battery pack and the motor to make sure that they are secure.
Check the status b of the battery pack by pressing the Test Button on side ,of the unit.
REDLED: The battery pack needs to charge.
GREEN LED: the battery pack is charged and ready for use.
NO LED ON: Plug the battery pack into an outlet to recharge.
Wait 30 seconds for the RED LED to illuminate, indicating it is charging

Problem:
LED Indicator Light
Does Not Light Up
When Plugged into the Wall Outlet

Confirm AC Power Supply Cord is properly connected to the battery pack and the wall outlet.
Confirm the outle t used for charging is working properly.
N ext Steps: If the battery pack does not hold a charge as indicated, contact customer service at 888-987-1077 or customerservice888-987-1077%20Next%20Steps:%20If%20the%20battery%20pack%20does%20not%20hold%20a%20charge%20as%20indicated,%20contact%20customer%20service%20at%20<a%20href=) or [email protected]) Next Steps: If the battery pack does not hold a charge as indicated, contact customer service at 888-987-1077 or [email protected]">@raffel.com

Problem:
Battery Does Not
Hold A Charge

C harge the battery Allow 7 hours to fully charge the battery pack. It may be beneficial to disconnect the battery from the furniture during charging.
Note: The number of recline cycles the battery can execute depends on the size of the occupant and the number ofaccessories connected to the system such as USB chargers.
Additional notes:n A fully charged battery pack provides >200 cycles, depending on furniture use and configuration. The battery pack will discharge when idle, but not completely drain the battery

HOW TO INSTALL THE BATTERY PACK

Check to see if the battery pack is fully charged before use by pressing the Test Button on the side of the unit.
If red, the battery needs to charge.
If green, the battery is charged and is ready to be installed.

FOR 2 OR 3 SEAT SECTIONALS

Connect the Y cord’s female 2 PDC to the furniture’s male 2 PDC.

Connect one of the Y cord’s female 2 PDC to the extension cord’s male 2 PDC.

RAFFEL BP536 Battery Pack for Motion Furniture fig 6

Connect the extension cord’s female 2 PDC to the furniture’s male2 PDC.
TWO SEAT SECTIONAL

Connect the Y cords’ female 2 PDC to the furniture’s male 2 PDC.
Note: Place the battery away from the furniture’s actuators. Examples of where to place the battery:

RAFFEL BP536 Battery Pack for Motion Furniture fig 7