ZillionSource ZT-28E Environmental Variable Collector For Logistics User Guide

June 6, 2024
ZillionSource

ZillionSource ZT-28E Environmental Variable Collector For Logistics User

Guide

Item List

Product Introduction

FIG 2 Product Introduction.JPG

Function Introduction

  1. Activation: ZT-28E needs to be activated. How: Pull out the activation tag on the back of the device. The signal light in the front of the device will flash after activation to indicate the first data report, and then turn off.
  2. Charging: ZT28-E uses a Type-C USB charging cable to charge.How: Connect the device and a 5V charger using a Type-C charging cable . The Charging Indicator will light up during the process, and turn off upon charging completion.

How to use

Place the device inside the container or asset to be monitored. Device will collect data according to business rules configured on the management portal.

**** Attention

  1. Device uses 2G and LTE-M communication; in areas without 2G/LTE-M, device will cache data.
  2. Please do not place device below -30C or above 60C for extended period of time.
  3. Please charge the device in an environment where temperature is within 5C- 30c.
  4. Information on sensor accuracy is from sensor manufacturers; accuracy on site may vary.
  5. Device needs to be charged using proper power source.
  6. Do not submerge the device in water.

Specifications

FIG 4 Specifications.JPG

*The specifications are just for your reference. Products shall be subject to changes without notice.

Service

Contact us:
ZillionSource Technologies Co., Ltd.
Service Hotline: +86-21-61212023
Email: support@zillionsource.com

For More Information, please go to www.zillionsource.com

FCC RF Exposure Information and Statement
This device meets the government’s requirements for exposure to radio waves. The guidelines are based on standards that were developed by independent scientific organizations through periodic and thorough evaluation of scientific studies. The standards include a substantial safety margin designed to assure the safety of all persons regardless of age or health. The SAR limit of USA (FCC) is 1.6 W/kg averaged. Device types: Environmental variable collector for logistics (FCC ID: 2ACRJ-ZT-28E) has also been tested against this SAR limit. SAR information on this and other pad can be viewed on-line at http://www.fcc.gov/oet/ea/fccid/. Please use the device FCC ID number for search. This device was tested simulation typical 10mm to body. To maintain compliance with FCC RF exposure requirements, use accessories should maintain a separation distance between the user’s bodies mentioned above, the use of holsters and similar accessories should not contain metallic components in its assembly, the use of accessories that do not satisfy these requirements may not comply with FCC RF exposure requirements, and should be avoided.

FCC Warning
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

  1. This device may not cause harmful interference, and
  2. this device must accept any interference received, including interference that may cause undesired operation.

NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

NOTE 2: Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Read More About This Manual & Download PDF:

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals