LUXPRO LP1512 Rechargeable LED Lantern User Manual
- June 6, 2024
- LUXPRO
Table of Contents
LUXPRO LP1512 Rechargeable LED Lantern
Features
- Dual battery design
- Rugged-durable rubber design
- 360° LED technology
- Power bank to charge other devices
- Variable on/off brightness dial
- IPX4 waterproof rating
- Rechargeable 2000mAh Li-ion battery (USB cable included)
Operation Instructions
On/Off: Turn the dial on the front of the lantern clockwise to turn the
light on. Turn the dial counterclockwise completely to turn the light off.
There will be an audible click when turned on or off.
Adjust Brightness: Rotate the dial clockwise to increase the brightness,
and counterclockwise to decrease the brightness.
Charging Instructions
Charging Product:
The LP1512 uses a Li-poly: 3.7V 2000 mAh rechargeable battery.
To charge the lantern, locate the USB dust cover below the power dial. Lift
the cover to expose the two charging ports.
Plug the supplied USB cable into the smaller USB port on the left. Plug the
opposite end of the cable into a USB power source.
A red LED light in the charge port will light up to indicate the lantern is
charging. The light is fully charged once the light turns green.
The lantern will turn on and can be used while charging.
The LP1512 has a charge time of approximately 3 hours.
Charging Other Devices:
The LP1512 can also be used as a power bank to charge other devices. To use as
a power bank, plug the large end of your charging cable into the larger USB
port on the right, and plug the opposite end of the cable into your electronic
device.
While the lantern is on, it will not charge other devices. If the lantern is turned on while charging a device, it will stop charging the device until the light is turned off.
Battery Replacement
The LP1512 can also be used with 3 C cell batteries (not included). To use with batteries, turn the base of the lantern counterclockwise to remove it. Insert batteries according to the (+/-) symbols outside of the battery tubes. The symbols indicate which side of the battery should be facing up. For best results, we recommend using brand new alkaline batteries that are the same voltage and brand.
Re-attach the base of the lantern by aligning the base to the lantern, pressing down lightly, and turning clockwise until tight.
The lantern will utilize the power from the internal rechargeable battery
first, then utilize the C cell batteries.
If you know it will be a while between uses, we suggest removing the batteries
from the lanANSI/PLterATn and stO FL1 SorTANDARing it in a drD y, protected
place.
Product Warranty
The LP1512 has a Limited Lifetime Warranty Against Manufacturer’s Defects from
time of purchase.
For warranty claims please contact us by calling
801-553-8886 or sending an email to
info@simpleproducts.com
luxpro.com
14725 S Porter Rockwell Blvd Ste C Bluffdale, UT 84065
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>