Vibe sound BTS21 Mobile Bass LED Wireless Speaker User Guide
- June 6, 2024
- Vibe sound
Table of Contents
Vibe sound BTS21 Mobile Bass LED Wireless Speaker
CHARGING THE SPEAKER
- Charge the speaker before using it for the first time.
- Plug in the coble ta the micro USB port and charge for 2 hours.
Connect the charging cable to charging port.
FEATURES/PARTS
- Press ta switch modes: Bluetoath / USB / TF Card / AUX/FM .
- (-) Press for previous song. Press and hold to reduce volume.
- Press to play/ pause music/ scan.
- (+) Press for next song. Press and hold to increase volume.
PAIRING YOUR SPEAKER
Your speaker will work best if it is within 30 ft. of your smart device. Yau may experience sound briefly cutting off if you are out of ronge or if your wireless connection is weak. Make sure Bluetaath is enabled on your smart phone or tablet before starting the pairing process.
- Tum on the speaker by flipping the Power Switch to the “On” position. The speaker will “beep when it is ready to connect
- From your smart phone or table find o list of nearby devices andchoose’ DG-SQST”. Enter “0000 if asked. The speaker will’beep’ again when pairing is complete!
SPECIFICATIONS
- BLUETOOTH VERSION: vs.1
- OUTPUT POWER: SW
- IMPEDANCE: 30
- FREQUENCY RESPONSE: 100Hz-20KHz
- WIRELESS RANGE: 10m
- PLAY TIME: UPTO 2 HOURS
- STANDBY TIME: UP TO 8 HOURS
- CHARGING TIME: – 2 HOURS
- BATTERY CAPACITY: 1200 MAH
- BT ID: D044460
- FCC ID: 2AANZ- BTS21SKU:DG-SQST-BT21
WARNING
- Keep away from water and moisture.
- Keep away from heat sources.
- Do not disassemble.
FCC STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Please note that changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment
FCC INSTRUCTIONS FOR A CLASS B DIGITAL DEVICE OR PERIPHERAL
Note : This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference ta radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
- RF warning statement:
- The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>