CarQiWireless FF150 Car Wireless Charger User Manual
- June 6, 2024
- CarQiWireless
Table of Contents
FF150 Car Wireless Charger
User Manual
Package Contents
- Wireless Chargers
- Anti-8lip Mat
- Rubber Pad AXT
- Rubber Pad Bx1
- Car Chargerx1
- Type-C USB Cable.x1
- User Manual&1
Lamp Status Description
| Item | Status | Description |
|---|---|---|
| Switch | Blue Light On | Power On |
| Blue Light Off | Power Off |
LED Indicator
Light| Green Light On| Charging
Green Light Flashing| Error/FOD
White Light On| Fully Charged
Specification
| Product Name | Car Wireless Charger |
|---|---|
| Model | FF150 |
| Input | 5V= 2A 9V=1.7A |
| Output | 5W,7.5W,1 OW |
| Working Frequency | 115KHz-205KHz |
| Charging Efficiency | 78% Max |
| Coil Quantity | 1 |
| USB Port Output | 5V/1A |
Installation Steps
-
Open the cover of the center control armrest box, and you can also remove the storage box that comes with the car according to personal preference.
-
Insert one end of the Type–C USB Cable into the Wireless Charger and the other end into the USB interface of the Car Charger Turn up the cigarette lighter cover and insert the Car Charger.
-
Push the car’s own storage box to the passenger’s side, install the Wireless Charger by aligning the front and rear grooves of the armrest box, slightly move and adjust it to fit with all parts of the car, to ensure that the Wireless Charger will not slide easily .
-
Turn on the switch of the Wireless Charger, and then place the phone compatible with QI standard on it to be charged You can also pass the charging cable through the small hole in the storage compartment and connect the phone for direct charging.
-
Put in the corresponding Rubber Pad A and B, and you can place some items such as pens, cigarettes, lighters, and coins according to your personal preference
FGCID 2AS5P.FF150
FCC WARNING’ This device complies with part 15 of the FCC Rules Operation is
subject to the following two conditions (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation Any changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
NOTE. This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of th6 FCC Rules, These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications However, there is no guarantee that interference will not occur
in a particular installation If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures
- Reorient or relocate the receiving antenna
- Increase the separation between the equipment and receiver
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
- Consult the dealer or an experienced radio/TV technician for help.
To maintain compliance with FCC’s RF exposure guidelines, This equipment should be installed and operated with a minimum distance between 20cm of the radiator your body Uses only the supplied antenna.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>