Shenzhen Tangzao Technology HAD Car Wireless Charger User Manual
- June 6, 2024
- Shenzhen Tangzao Technology
Table of Contents
Shenzhen Tangzao Technology HAD Car Wireless Charger User Manual
Thank you for purchasing from CarQiWireless, the designer of 100+ different wireless chargers for different cars.
If you are not satisfied with our products, plee.se reach out to us, we would love the opportunity to make it right, simply send us a message. lf you are happy with our products, sharing your experience will greatly help other owners find the right accessories for their cars and also inspire us to design the best products for the community.
Again, we appreciate your trust and support to CarQiWireless.
Package Contents
- Wireless Charger x 1
- Anti-slip Mat x 1
- Rubber Pad x 1
- Car Charger x 1
- Type-C USB Cable x 1
- User Manual x 1
Lamp Status Description
Specification
Installation Steps
-
Push the handbrake to the rear, open the cover of the central storage compartment, and take out the rubber pad that comes with the car.
-
Plug one end of the Type-C USB Cable into the Wireless Charger, fix it 1hrough 1he round slot beside, and insert 1he other end into the USB port of the Car Charger.
-
Install the Wireless Charger, slightly move end adjust ii to fit with the car. Turn over the cover of the clgare1te lighter and insert the Car Charger.
-
Turn on the switch of the Wireless Charger, and then place the phone compatible wi1h QI standard on It to be charged.
-
Put in the attached Rubber Pad. You can s1ore some small items here, such as keys, USB flash drives, coins, etc.
Nota:
- lf you want to take out the Wireless Clara, you can lift the cable to bring out the Wireless Charger, and then take it out by hand.
- Do not install the Wireless Charger without the charging cable into the car separately.so as to avoid difficulty in taking it out.
FCC ID: 2AS5P-HAD
FCC WARNING: This device complies with part 15 oi the FCC Rules. Operation is
subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user ‘s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules . These limits
are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
— Reorient or relocate 1he receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
To maintain compliance with FCC’ s RF Exposure guidelines, This equipment
should be installed and operated with minimum distance between 20cm the
radiator your body: Use only the supplied antenna.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>