FULLER ST200 4 LED Lights Edge Stud Finder Instructions
- October 27, 2023
- FULLER
Table of Contents
ST200 4 LED Lights Edge Stud Finder
Instructions
ST200 4 LED Lights Edge Stud Finder
POWER SUPPLY
The tools require one 9 volt battery to operate
BATTERY INSTALLATION
- Squeeze sides of unit to help release clip end.
- Slide 9V battery into compartment, terminal side first, matching (+) and (-) terminals from battery to case.
- Replace the clip. Battery life is approximately 50 hours.
Using the detector
- Position the unit flat against the wall.
- Press on/off button and hold in.
- Slowly slide unit horizontally across the wall, right or left. As you begin to approach a stud, the Yellow LEDs will light, from bottom to top.
- When the top Red LED is light and the beep sound, you have located the edge of the stud. Mark this spot.
- Continue scanning beyond the marked spot until the yellow LEDs go out. Slide unit in reverse direction to locate other edge of stud.
- Mark this second spot. Between the two spots is the stud position.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>