Shenzhen Ldtek Technology WT396 E.Power 2400mAh Power Bank with Solar User Manual
- June 6, 2024
- Shenzhen Ldtek Technology
Table of Contents
Shenzhen Ldtek Technology WT396 E.Power 2400mAh Power Bank with Solar
IDENTIFYING PARTS
- (D Hook
-
- On/Off Buttcn
- @ LED Power lndicatDr
- Solar Panel
- BED Soler lndlca1Dr
- USBoutputMicro USS 111)U
- USB-C lnput/Oulput
- USBoutput
Spotlight button (short press this button to turn on the spotlight. Press this button again to switch the lighting mode)
SPECIFICATIONS
- Package Includes
- x E.POWER 24000mAh Power Bank With Solar
- 1 x Micro USB Cable (30 cm/ 24 in)
- 1 x USB-A to USB-C Cable (30 cm 124 in)
- 1 x User Gulde
- 1 x Carablner
Note : When charging via aolar, the green Solar LED Indicator light tum on. When charging via USB, the light will not tum on. In both cases, the blue LED Power Indicators will tum on to display battary levels.
RECHARGING THE POWER BANK
- Recharged by the sunlight.
- Place the panel In direct sunlight. Recharging will start with the green LED Indicator tumbling on end the blue LED Indicators lighting up one by one according to the battery levels.
Note: the recharging time may vary according to ID the intensity of sunlight. Recharged via the USB input port. Use the included USB cables to recharge your power bank through electrical outlets and more until all 4 LED indicators become solid blue.
OPERATIONS
- Connect your devices to the outputs of the power bank with USB cables and charging will start automatically. The blue LED indicator(s) will tum on to show the battery level.
Note: – recommend you to use original Appl& cables ID charge
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation
NOTE : This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures: Reorient or relocate
the receiving antenna. Increase the separation between the equipment and
receiver. Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.Consult the dealer or an experienced
radio/TV technician for help.
Warning: changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment This equipment complies with FCC radiation exposure limits set forth
for an uncontrolled environment. This equipment should be installed and
operated with minimum distance 20cm between the radiator and your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>