Murata Manufacturing LBCA2HN2AH Communication Module User Manual
- June 6, 2024
- Murata Manufacturing
Table of Contents
Murata Manufacturing LBCA2HN2AH Communication Module
OverView
Since this module is not sold to general end-users directly, there is no user manual of the module. For the details about this module, please refer to the specification sheet of module. This module should be installed in the host device according to the interface specification (installation procedure) The OEM integrator has to be aware not to provide information to the end user regarding how to install or remove this RF module in the end user’s manual of the end product which integrates this module. The end user manual shall include all required regulatory information/warning as shown in User manual.
- FCC CAUTION Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
- This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.
- This device complies with part 15 of the FCC Rules. Part 15 Subpart C
- Since there is no space that indicates FCC ID on this module, FCC ID is indicated in a manual. If the FCC ID is not visible when the module is installed inside another device, then the module is installed must also display a label referring to the enclosed module.
- The modular transmitter is only FCC authorized for the specific rule parts (i.e., FCC transmitter rules) listed on the grant, and the host product manufacturer is responsible for compliance to any other FCC rules that apply to the host not covered by the modular transmitter grant of certification.
- The final host product still requires Part 15 Subpart B compliance testing with the modular transmitter installed.
Antenna list
Part number | Vendor | Peak Gain(dBi) | Type | Connector |
---|---|---|---|---|
AIR-ANT2460P-R | Cisco | 5.5 | Patch | U.FL |
S171AH-2450S | Nearson | 6.5 | Dipole | U.FL |
Internal Trace Antenna | Murata | -1.0 | Monopole | – |
The following information must be indicated on the host device of this module.
- Contains Transmitter Module FCC ID: VPYLBCA2HN2AH or Contains FCC ID: VPYLBCA2HN2AH
FCC Compliance Information
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. *If it is difficult to describe this statement on the host device due to the size, please describe in the user’s manual and also either describe on the device packaging or on a removable label attached to the device.