VICTOR VLINK V430 Power-Kill Pro Rat Snap Trap User Guide

VICTOR VLINK V430 Power-Kill Pro Rat Snap

installation

ACCOUNT SET-UP

1. Before you begin, confirm that you have a VLINK account created and an Admin has added you to the account. Contact your VLINK sales representative for confirmation if you are unsure.
2. Confirm that you can successfully log-in at www.vlinkhq.com.

CONNECT THE GATEWAY

Plug in the gateway. If you are planning to use your local network, plug your ethernet cable into the ethernet port. For all other gateway instructions, refer to the manual provided with the unit.

DOWNLOAD THE APP

1. Search for the Victor VLINK® app from the Apple App Store or Google Play Store and download to your device.
2. Log in using your VLINK® account credentials.
3. Launch the app and follow the on-screen instructions to connect your trap to the app.

BAIT TRAPS

Paste Baits

1. Place paste baits in the bait cup container.
2. Place bait in cup firmly to prevent it from being pulled out easily by the rodent.
3. Placing bait on the trigger petal may lead to non-capture triggers.

Tied Baits

1. Tie desired bait to raised Victor® V.
2. Orient bait towards middle of trap pedal.

CONNECT TRAP TO THE NETWORK

1. Hold the back end of the trap, place both thumbs on the thumb grips.
2. Pull bar back into the easy-set latch until it clicks and locks.
3. Take notice of LED light sequences on the back left corner of the trap.

NOTE: Setting the trap can only be successfully accomplished if the trap is level. If it is tilted significantly, it will not set.

LED Light Sequences

1. Green Flash When Set: The trap Is set and fully powered on.
2. Yellow Flash: The trap is disengaged and in power-saving mode.
3. Red Flash When Set: The trap is set but the battery is low.
4. Blue Flash: The trap successfully communicated with the network.

PLACE TRAP

Once your trap is connected, place it in the area of rodent activity and wait for the trap to alert you of a capture.

RESET TRAP AFTER A KILL

1. If a rodent has been captured, record your kill data using the VLINK Mobile App.
2. Once the rodent is removed, the trap is ready to be baited and reset for another capture.
3. To reset, simply pull the kill bar back to the set position and wait for the green and blue LED flashes to let you know the trap is communicating and ready for another kill.

Pro Tip: Avoid using strong cleaning products on the traps. A captured rodent can leave behind scent and odor that can make the trap more attractive to other rodents.

Federal Communications Commission

References

• VLINK™ | Innovative, Remote Rodent Control from Victor®

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>