Pyronix 102028024-01 Wireless Speaker Sounder User Guide

Wireless Speaker Sounder
USER GUIDE
Document SAP: 102028024-01

This product contains a flashing light that may potentially trigger seizures for people with photosensitive epilepsy
Dimensions and weight Please see the diagram for the dimensions and weight of the product.
Sounder overview

A. Alarm volume adjust
B. Chime volume adjust
C. Visual indicator area
D. Speaker

1. Configuration mode
   Whilst powered up, press both the alarm and chime volume adjust buttons simultaneously and hold for 2 seconds. The blue LED will illuminate to indicate the sounder is in configuration mode. Configuration mode will automatically timeout after 10 seconds of inactivity.

2. Enabling and disabling the light
   Press both the alarm and chime volume adjust buttons simultaneously whilst the sounder is in configuration mode to switch between the light enabled and disabled. The white light will extinguish/illuminate to show the current setting.

3. Alarm volume
   In configuration mode, press the alarm volume adjust button to cycle through volume levels 1 to 4 and mute. The red LED will illuminate whilst cycling through. The first button press plays the Alarm tone at the current setting, subsequent presses adjust the volume.

4. Chime volume
   In configuration mode, press the chime volume adjust button to cycle through volume levels 1 to 4 and mute. The red LED will illuminate whilst cycling through. The first button press plays the Chime tone at the current setting, subsequent presses adjust the volume.

5. Exiting configuration mode
   The sounder will automatically exit configuration mode if no buttons have been pressed on the device for 10 seconds.

6. Mains fail operation
   – Audible response
   The device will double beep 5 times and then will pause for 30 minutes. At the end of 30 minutes, the device will enter a cycle of double beeping 5 times then pausing for 10 seconds. The cycle will repeat until the device runs out of battery, the device is turned off or the mains power is restored.
   – Visual response
   The device will illuminate and stay illuminated until the device runs out of battery, the device is turned off or the mains power is restored.

7. Powering the device off
   Switch mains supply off or remove the device from the wall socket. Press and hold both volume buttons until the device LEDs all extinguish.

Specifications

Casing
3mm polycarbonate
LED colors
Blue, red, green, and white
Transmission frequency
868MHz FM transceiver narrow band
Transmission method and range
Fully encrypted rolling code, 300m
Operating voltage
230VAC ±5%, 50Hz
Operating current
40mA @ 230VAC
Operating temperature
-10 to 40ºC
Battery
3.7V 250mAh, Lithium-ion, non-replaceable

Alarm response
– Audible response
Rapid tones alternating high and low.
– Visual response
Rapid flashing white LED light.
Chime response
– Audible response
Slow repeating tones (if chime follow is selected) or singular tone otherwise.
– Visual response
Slow flashing white LED light.
Fire and personal attack response
– Audible response
Slow tones alternating from low to high.
– Visual response
The white LED illuminates and stays on constantly.
Entry and/or exit response
– Audible response
A constant tone is on whilst the entry or exit timer is active.
– Visual response
The white LED illuminates and stays on constantly.

Product information

Applies to electrical products sold within the European community. At the end of the electrical product’s life, do not dispose of it with household waste. Where possible, recycle the product. Check with your Local Authority or retailer for recycling advice in your country. When disposing of the product, the battery must be removed and disposed of separately in accordance with the local regulations.
Hereby Pyronix declares that this product is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU.
The declaration of conformity may be consulted at www.pyronix.com/product- compliance.php

Warranty

This product is sold subject to our standard warranty conditions and is warranted against defects in workmanship for a period of two years. In the interest of continuing care and design, Pyronix Ltd reserves the right to amend specifications without giving prior notice.

+44(0)333 444 1280 (UK)
customer.support@pyronix.com
www.pyronix.com
Pyronix Limited, Pyronix House, Braithwell Way, Hellaby, Rotherham, S66 8QY, UK

References

• Security Systems Manufacturer for Home & Business | Pyronix
• Product Compliance Certificate | Security System & Technology Downloads | Pyronix

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>