Mingxing Toys Factory MX-Series RC Boat Instruction Manual
- June 6, 2024
- Mingxing Toys Factory
Table of Contents
MX-SERIES R/C BOAT INSTRUCTION MANUAL
Battery Installation
-
Screw opens the battery compartment cover from the boat, insert 3 pieces of 1.5V -AA” batteries (Not included), following the correct polarity. Screw close the battery cover.
-
Screw open the battery compartment cover from the remote control, insert 2 pieces of 1.5V “AAA” batteries (Not included), following the correct polarity. Screw close the battery cover.
-
Do not mix new and used batteries or batteries of different types.
-
Only batteries of the same or equivalent types as recommended are to be used.
-
Do not mix alkaline batteries with rechargeable batteries.
-
Gently pull out the battery lid when the screw is loosened. The battery lid is more difficult to be removed due to the water-proof ring inside.
Operation Instructions: After use, pull out the plastic plug in the drain
hole to drain the water.
Operation Manual of Remote Control
- Don’t operate your boat where there are water plants, rubbish, or other obstacles in the pond.
- This could impair the propeller and cause damage.
- Don’t play when there is a strong water current or when the wind is blowing strongly on the pond. ‘
- Never play in ocean(salt)water. This will cause rusting of parts.
- Don’t play outdoors during thunderstorms.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/IT technician for help
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>