YENKEE YHP 03BT Rage Gaming TWS Earphones User Manual

October 27, 2023
YENKEE

YHP O3BT RAGE

USER’S MANUAL
Gaming TWS earphones RAGE

1. Charging contacts
2. LEO indicator
3. Multifunction touch button| 4. Charging contacts
5. Microphone
---|---

Putting into operation

Before first use, be sure to read the safety instructions contained in this user’s manual carefully.
Before first use, please charge the BT earphones to a maximum level. The earphones are automatically ready to use after removing fram the charging box.

Caution: To prevent damage to your hearing, before connecting the BT earphones to your mobile phone, make sure that your device’s volume level is always set to minimum.

Note: The BT earphones will turn off after a longer period of inactivity unless they are paired to another device.

Pairing your headphones via Bluetooth

Open charging box cover and wait until earphones pair with each other and master earpad LED start to flash green light constantly. Find “RAGE” in available Bluetooth devices in your mobile phone or another device ta which you wish to pair earphones and start the pairing process.

Note: You can also put earphones in your ears and audio signal “pairing” will announce you pairing mode and ,,cannected” will announce your earphones were paired with your Bluetooth device.
In case you dont see ,RAGE” in available devices, check if Bluetooth is turned ON in your device (restart Bluetooth in case of future invisibility).

Note: To ensure a stable Bluetooth connection, make sure that the distance between the BT earphones and your paired device is kept within 10 meters. Depending on the surrounding interference, it is sametimes necessary to keep a shorter distance between the BT earphones and your paired device.

Note: If you are requested to enter a pairing code while your device and the BT earphones are pairing, use the following code: “ODUO”.

Operation of the BT headphones

  • Turning the BT earphones ON: Hold down the multifunction touch button on both earphones for 2 seconds. By opening charging case earphones will automatically cannect with last used device. Simply place them in ears and double tap to play your playlist.
  • Turning the BT earphones OFF: Hold down the multifunctian touch button on both earphones for 5 seconds. Inserting the BT earphones in the charging box will disconnect them from the bluetooth transmission, turn them off and start their charging autamatically.
  • Answering/ending a phone call: The incoming call an a paired mobi- le device is announced by the 5 beep sounds. To answer/end an incoming call double tap the  multifunction touch button an any earphone.
  • Rejecting an incoming call: To reject an incaming call ta a paired mobile device, hold down the multifunction touch button on the any earphone for 2 secands until the  call is rejected.
  • To start/pause the music playback: To start/pause the music play- back from your connected mobile device, double tap the multifuncti- on touch button on any  earphane shortly.
  • Volume up/down: Single tap on left earphone for volume down. Sin- gle tap on right earphone for volume up. Maximum volume is announ- ced by beep saund in right  earphone.
  • Previous/next track: For previous track triple tap the multifunction touch button on the left earphone. For next track triple tap the multi- function touch button on the  right earphone
  • Voice assistant: To enable this feature on your paired mabile devi- ce, hold the multifunction touch button on the left headphone for 2 seconds. The voice assistant  feature availability depends on the type and settings of your mabile device. Voice assistant activation is an- nounced by beep sound in left earphone.
  • Game/music mode: To switch between game/music made hald the multifunction touch button on the right headphone for 2 secands. single beep sound will announce  that mode change was performed.
  • Factory reset: Disconnect earphones by switching OFF bluetooth on paired device. Quickly tap 5 times ta the master earphane [the one which i flashing green]. Both  earphones indicators will flash for 3 seconds and than turn OFF. After that put them back in ta charging case and factory reset is finished.

LED indicators

Earphones:
Power ON: green indicator flash 3 times
Power OFF: green indicator flash 1 time
Disconnected: right (master) indicator flash 2 times per second
Game mode: green indicator is in breathing lignt mode
Low battery warning: both green indicators (L/R) flash every 2 seconds si- multaneously
Earphones are charging: green indicator ON Earphones are charged: green indicator OFF

Charging case:
Charging case in charging:
Case indicators 1x flash – battery less than 25%
Case indicators ex flash – battery 25% – 50%
Case indicators 3x flash – battery 50% – 75%
Case indicators 4x flash – battery 75% – 100%
Allways ON – battery fully charged
When earpods are charged in charging case, open and close case to see earpod charging status. If both case indicators remain ON after case cover closed, charging is still in  process.

Charging

A charged battery provides power for several hours of operation at normal volume levels. A high volume consumes more battery power;
therefore, we recommend listening at normal volume levels.
After inserting the earphones in the charging box as well as while the box is being charged, the LED indicators on the front shows the charging level (25%, 50%, 75%, 100%).
Caution: For charging, use only the original accessories supplied with the appliance. To achieve the maximum battery lifetime, it is best to start charging the battery after the  low battery power notification.
Charge continuously until fully charged. When the operating time of the battery becomes very short, the battery’s lifetime has been use up.
Recommendation: If your earphones are not to be used for an extended period of time, we recommend to fully charge the batteries once every two to three months, We  recommend to store the BT earphones and the charging box with the battery charged to prevent irreparable damage to the battery (loss of capacity].

Specification:

Bluetooth: v5.0 | Latency: 65ms | BT profiles: A2DP/AVCTP/AVDTP/ AVRCP/HFP/SPP/SMP/ATT/GAP/GATT/RFCOMM/SOP/L2CAP | Cperating range: <10m | Charging voltage: OC 5V [Type C) | Charging time: < e h | Playback time: < 6h | Speakers diameter: 1@mm | Frequency response: 20-175Khz | Sensitivity: 110dB |  Impendance: 32Q | Maximum transmitter power at 2.4 GHz – 2.4835 GHz: 10 mW | Charging case capacity: 400mAh (Lithium polymer) | Earphone capacity: 5OmAh (Lithium polymer) | Charging case dimensions: 85 x 47 x 32mm | Earphone dimension: 39 x 22 x 22mm | Charging case weight: 53 g | Earphone weight: 5 g

Instructions  and information regarding the disposal of used packaging materials
Dispose of packaging material at a public waste disposal site.

Disposal of used electrical and electronic appliances
The meaning of the symbol on the product, its accessory or packaging indicates that this product shall not be treated as household waste. Please, dispose of this product at  your applicable collection point for the recycling of electrical & electro- nic equipment waste. Alternatively in some states of the European Union or other European states  you may return your products to your local retailer when buying an equivalent new p roduct.
The correct disposal of this product will help save valuable natural resources and help in preventing the potential negative im pact on the environment and human health,  which could be caused as a result of improper liquidation of waste. Please ask your local authorities or the nearest waste collection centre for further details.
The improper disposal of this type of waste may fall subject to national regulations for fines.
For business entities in the European Union
If you wish to dispose of an electrical or electronic device, request the necessary information from your seller or supplier.
Dispasal in other countries outside the European Union If you wish to dispose of this product, request the necessary information about the correct disposal method from  local government departments aor from your seller. This appliance complies with EU rules and regulations regarding electramagnetic and electrical safety.
Changes to the text, design and technical specifi cations may occur without prior notice and we reserve the right to make these changes.
Hereby, FAST CR, a.s. declares that the radio equipment type [YHP O3BT BK] is in compliance with Directive 2014/53/EU. The full text of the EU declaration of  conformity is available at the following internet address: www.yenkee.eu

Manufacturer: FAST GR, a.s.
U Sanitasu 1621
25101 Ricany
Czech Republic

Documents / Resources

| YENKEE YHP 03BT Rage Gaming TWS Earphones [pdf] User Manual
YHP 03BT Rage Gaming TWS Earphones, YHP 03BT Rage, Gaming TWS Earphones, TWS Earphones, Earphones
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals