NextCentury TR4 Transceiver User Guide

June 6, 2024
NextCentury

NextCentury TR4 Transceiver

Meet the next generation of the NextCentury Transceiver. The TR4 (indoor) is part of an advanced meter-reading solution that can transform almost any meter into a wireless smart meter, enabling it to automatically connect to the NextCentury Cloud Platform. Setup and installation of the Transceiver is quick and easy.

Package Contents

A) TR4 (Qty: 50)

B) Mounting Plate (Qty: 50)

C) Sheetrock Anchors (Qty: 100)

D) Screws #6-20 (Qty: 100)

Meter+TM Technology

Meter+TM Technology has been developed to allow a Transceiver model to connect to virtually all modern submeter outputs. These include a variety of different pulse-out meters as well as encoded output meters. Meter+TM Encoder technology supports Sensus, Neptune, Amco, Elster, and GWF 3-wire protocols. Simply wire the meter and Transceiver with the proper configuration, and it will automatically detect which protocol to use. The Meter+TM Smart Pulse detection allows the Tranceiver to detect, correct, and report faulty (ghosting) reed switches.

Additional Resources

For full installation guide, spec sheets, and additional resources, please visit: products.nextcenturymeters.com/tr4

Contact Information
Phone: 844.538.8203 opt. 2 Email: support@nextcenturymeters.com

Installation

Mounting On Wall

Remove the mounting plate from the Transceiver

Anchor the mounting plate using the included hardware or tape

Slide the Transceiver back onto mounting plate

Mounting On M201 Meter

Attach M201 mounting plate (included with M201 meters)

Slide the Transceiver on the meter mounting plate

Using Pre-installed Pulse Connector

When using a meter with the pre-installed pulse connector, simply attach it to the IN and GND posts of the Transceiver. The two posts are labeled and marked with an outline for your convenience.

Wiring Guide

Interactive Wiring Guide

An interactive Wiring Guide is also available through the NextCentury Mobile App (Android and iOS Support).

Check Configuration
  1. Press and hold the Test Connect button for 5 seconds to enter Configuration Mode

  2. The Meter LED will display a solid color to show the current meter type configuration
    Red Meter LED = Encoded
    Blue Meter LED = Pulse

  3. Tap the Test Connect button to toggle between Pulse Meter (red) and Encoded Meter (blue) configurations

  4. After 3 seconds, the meter type is accepted

  5. If configured for Encoded, the Meter LED will blink green when wiring is correct

Cloud Connected

Wireless Made Easy

When installing NextCentury Transceivers, you can instantly know if everything is working correctly by tapping the red Test Connect button. The Transceiver’s RF LED will blink when it is able to communicate with its Gateway

Programming

Programming Transceivers can be completed quickly on the NextCentury Web or Mobile App, either ahead of time or on-site. To receive immediate feedback with the Test Connect button, make sure the Gateway is programmed and connected to the NextCentury Cloud.

Mobile App Download

|
---|---

App Store iOS App

|

Google Play Android App

Additional Products

  • Cellular Gateway
  • Wireless Network Repeater
  • Pre-Programming: Equipment configured and ready for install

For more, visit:www.nextcenturymeters.com or contact sales@nextcenturymeters.com

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals