darEd MP-5BT iFi Vacuum Tube Amplifier User Manual
- June 6, 2024
- darEd
Table of Contents
darEd MP-5BT iFi Vacuum Tube Amplifier
Safety Instructions
Caution: To reduce the risk of electic shock . do not remove screws/ cover/back. No user-serviceable parts inside. The hghlning 11:ish w,!h :urowhud symbol, within to ti•• pr•unee of umns.ilateo dang•rou.s voltage within 1M product’ $ macro.sure 11\81 nuty be 01 shock IO Pl!IJ’$01\$ Tho trhmg1e ••c Is InamaUon tended point lo «lthalort ,n lh• an uffr oqul’atarol lo prc of important operating and maintenance nnc;• accompanying {servicirg)lnstruclion5 the applianc•.
Warning
To reduce the risk of fire. an electric shock or product damage. do not
expose this apparatus to rain, moisture. dripping or splashing and that no
objects filled with liquids. such as vases. shall be placed on the apparatus.
Repair and maintenance
Regular cleaning the dust on the surface of the machine When clearing must
close when the machine.
**Troubleshooting
**
II the unit falls to operate normally. check the following points to determine
whether the fault can be corrected by the simple measure suggested. If it
cannot be corrected . or if the fault is not listed in the SYMPTOM column.
disconnected the power card and contact your authorized dealer or service
center for help.
FCC warning
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by
the manufacturer could void your authority to operate this equipment. This
device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation.
RF Exposure Information
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>