Shenzhen Maizhan Technology MZF11PROA Fast Wireless Charge Dock User Manual
- June 6, 2024
- Shenzhen Maizhan Technology
Table of Contents
Shenzhen Maizhan Technology MZF11PROA Fast Wireless Charge Dock
Product Introduction
This Wireless Charge Dock is newly designed which can wirelessly charge your iPhone end Apple Watch simultaneously. The built-in magnetic charging module aligns your Apple watch magnetically, so you can be charge instantly. Instantly. With double coll wireless charging module and Apple Watch Magnetic Charging module, you can charge your phone in either portrait or landscape position, then it will be comfortable to browse webs, listen to music, or stream Podcasts.
Product Appearance
Smartphone and iWatth Charging Schematic Diagram
Product Specification
Input: DC12V=2A/9V=2A/5V=3A
Output: 15W/10W./7.5W/5W +3w
Transmission distance: ~8mm
Conversion nm: 73%
Product Size: 140Xl04Xl2lmm
Standard Accessories
- Wireless charging Dock
- Type-Cable
- User manual
FCC STATEMENT
This device complies with Part 15 of the FCC rules. Operation is subject to the follow Ing two conditions;
- this device may not cause harmful interference, and
- this device must accept any interference received. includin1 interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Partis of the FCC Rules. These limits are destined to provide reasonable protection a1ainst harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency anar1v and, if not installed and used in accord nee with the installations, may r;t use harmful Interference to radio communications. However, there Is no 1uarantee that Interference will not occur In a pa particular installation. If this equipment does cause harmful interference to radio or television reception. which can be determined by turning the equipment off and on, the user Is encouraged to try to correct the Interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment Into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The use distance should be more than 20cm from the human body